Your cart is empty.
Your cart is empty.Vehicles with automatic transmissions have a flex plate. The flex plates connects the engine and transmission. Most flex plates are made of a thick piece of sheet metal with bolt holes for the torque converter and teeth for the starter. The job of a flex plate is to allow for expansion of the torque converter as engine RPM increases. The constant expansion and contraction of a flex plate over time can result cracks and/or shearing of the flex plate. A damaged flex plate can create serious (expensive) damage. Broken flex plates can not be repaired, they must be replaced. ATP flex plates are made of high quality steel and contain the correct bolt hole spacing and ring gear teeth just like the original part to ensure long life and durability
Puppit
2025-09-06 18:59:11
Uneven welds, and definitely warped. Uneven welds will also cause imbalance. Won't be going in my truck. Won't even waste time putting it in. Wish I would have seen it sooner.
Michael Grist
2025-09-05 14:48:10
It was a perfect fit
Michael S.
2025-05-31 10:54:22
Poor quality and can’t handle any real torque. Now I’m pulling the engine because I wanted to save a few bucks on this part. Flaw in the stamping I assume.
kenneth guercio
2025-01-10 18:22:53
worked well good fit
Rob G
2024-11-23 12:50:35
Very cheaply made, sharp points at welds.
Recommended Products
$30.99
$ 13 .99 $13.99
$39.95
$ 18 .99 $18.99