Your cart is empty.
Your cart is empty.This digital automobile gauge (12V DC power) can be used to measure temperature, pressure and other important parameters, such as battery voltage and air/fuel ratio. The programmable alarm will turn on a LED in the front panel to get the driver's attention if the temperature/pressure is above the setting point. It will also close a relay output port that can be used to turn on a buzzer, shut off the fuel, or turn on a cooling fan. The meter stores the peak temperature/pressure with time stamps that can be checked later. It can also operate in the peak holding mode so that only the maximum value is displayed. The brightness of the LED display can be synchronized with headlight. It can also be dimmed directly from the key pad. Developed based on industrial grade instruments, this four digits gauge offers up to 10 times the resolution and accuracy of most 3 digits gauges on the market. Its compact size (24 x 48 mm or 1 x 2") takes less space than a 52 mm round gauge. For EGT measurement, the meter will work with all EGT sensors on the market, grounded or ungrounded. It can display the temperature in either Celsius or Fahrenheit. It is one of the most accurate exhaust gas temperature (EGT) monitors on the market. For boost pressure measurement, the meter will work with all MAP sensors as long as its pressure/output voltage relationship is known. It can display the pressure in either Bar, PSI, or user defined units with high resolution. For water/oil temperature measurements, the meter can display with 1 degree accuracy when use with PT100 sensor. It will also work with our liquid tight thermocouple based sensors. In addition, it can work with a VDO 150 °C (300 °F) sensor with a limited display range (50-150 °C/120-300°F). The meter offers a regulated 5V DC output for pressure transducer. For air/fuel ratio measurements, it can be used to display either air/fuel ratio or lambda when interfaced with an Innovate Motorsports' LC-1 wideband oxygen sensor controller.
WRX
2025-07-22 18:28:05
The display is easy to read and the buttons feel sturdy and have a good positive feel. The terminal board on the back is sturdy and has separators keeping the wires from touching each other. The size for me was perfect, I used the area below my stereo which wasn't being used anyway, and have plans to add 2 more of these(engine oil temp and boost).If your looking for a gauge for your car or truck I would stop here, this gauge is very well thought out in all aspects, accuracy, size, functions and features.
Charles S. Dobrovolny
2025-05-07 14:30:12
Works great and easy install in my truck. Wish I would have found the combo that includes the sender when I was shopping for this. Ended up spending a bit more to buy the thermocouple separately then I would if I would have seen the combo.
Boulat
2025-04-21 21:59:23
Do you care about your car's engine longevity?This device will show you whether your engine is adequately tuned up or not. Also it will tech you to drive your car properly: without putting your engine in risk yet getting much power possible.Device is well engineered, small, nice looking.
bill Zimmerman
2025-03-17 15:04:35
Works great, responds quickly to temperature changes.
Adam Neilsen
2024-12-05 12:36:23
I have had one of these on my 1991 Dodge Cummins for 4 years now along with the Auber EGT thermocoupler. It has worked perfectly and I love being able to get an instant readout of my EGT instead of trying to read a gauge like a watch. I have the LED alert set to come on at 1,200 degrees and it's nice and bright, and gets my attention even in daylight. I installed it where my cargo lamp switch used to be and the display is small enough that it fits perfectly. I set mine up with their instructions and haven't played with it since, I know it can do much more then I've used it for. I think I'll get another for a boost gauge, or perhaps their dual output model.
Recommended Products
$36.99
$ 17 .99 $17.99