Shopping Cart

Your cart is empty.

Your cart is empty.

Bassett-B10225 MCH-4R Series Solid Carbide End Mill, Uncoated (Bright) Finish, 4 Flute, 60 Degrees Profile Angle, Chamfer End, 0.84' Cutting Length, 1/2' Cutting Diameter, 3' Length (Pack of 1)

4.5 (1) Write Review
Free shipping on orders over $29.99

$13.19

$ 5 .99 $5.99

In Stock

About this item

  • Solid carbide tools offer long tool life and faster cutting speeds than other substrates, but are more brittle and must be used with rigid toolholding systems
  • Uncoated tools feature just the base substrate without any additional treatment or coatings and are suitable for a wide range of applications
  • Round shanks allow use with a wide variety of toolholding systems
  • When run in a counterclockwise direction (right-hand cut) spiral fluted tools evacuate chips up and out of the cut to reduce clogging
  • Applicable for steel, cast iron, nonferrous material
  • Made in the USA


Bassett MCH Series single end solid carbide 4 flutes chamfer tool. 60 degrees point angle. Applicable for steel, cast iron, nonferrous material.


Lee
2024-11-14 11:12:57
If you are just starting with milling then use a HSS end mill. I quickly broke this solid carbide mill.