Your cart is empty.
Your cart is empty.Product Description
The Belva BXA15001 is categorized as a Class A/B amplifier. This class of amplifiers combine the high efficiency of a class A amplifier and lower distortion found in class B amplifiers. The class AB amplifier acts more similarly to a class A amplifier by biasing both transistors so they become active when the signal is close to zero. As the signal excursion increases into a larger waveform, only one transistor remains active, a primary function found in class B amplifiers. These features combined with the MOSFET transistor allow the Belva BXA15001 to be one of the most efficient amplifiers on the market. The BXA15001 also features three-way protection circuitry which protects against thermal, overload, and speaker shortages. This configuration increases the longevity of both the amplifier and entire speaker system.
While other amplifiers on the market only feature a variable bass boost switch, the BXA15001 is equipped with a variable bass boost knob. This allows the user to fine tune the bass and gain in the amplifiers with more precision. The variable bass boost has a range of 0 to 18 decibels, whereas in other amplifiers in the same class, the range is only 0 to 12 decibels.
The BXA15001 has superior input flexibility features both high level and low level speaker inputs. The high level inputs allow the amplifier to be wired into factory stereos or an aftermarket stereo without low level RCA inputs. The low level speaker inputs means the complicated process of splicing the wire into the stereo can be bypassed.
General Features
- Class A/B Monoblock Amplifier
- Total Max Power: 1500 watts Watts
- 4 ohms: 750 watts x 1 chan.
- 2 ohms: 1500 watts x 1 chan.
- 96 decibel Signal-to-Noise ratio
- Bass Knob for Precision Tuning
- 3-way protection circuitry (thermal, overload, and speaker short protection)
- Pulse Width Modulated MOSFET power supply
Wendells28
2025-09-04 18:12:56
Use this to power two 12 inch subs, works great!
Unklejayjay
2025-07-24 11:01:11
I put this amplifier in this box works great in 4ohm mode gets a little warm push it hard no problemI like it got a lot of power . love the bass controlBoom boom!
Isaac Gurule
2025-07-18 14:50:40
This amp effen sucks bad! It doesn't put out out even a quarter of power as what's advertised! On top of that it heats up faster than most amps and shuts off. When I purchased it I figured Belva makes a lot of music stuff that are descent so they're amps gotta be descent as well WRONG!!
AJ
2025-07-17 12:20:55
I wasn't expecting much out of this amp, honestly I had basically only purchased it as a cheapo one ohm stable "transition" amp to push my subs at least kinda-somewhat (subs are 1,500 RMS each so wasn't expecting it to push them very much if at all) in the meantime until my actual amp for my build came in a month from now. The overall performance of this amp actually surprised me to be honest! And considering it's putting up a decent fight with my subs at one ohm is not what I had envisioned it being capable of doing, but sure enough it does! Granted it doesn't come anywhere NEAR pushing them to their max potential, but I didn't buy it with the hopes it would anyways. But ultimately it is actually a great little budget banger amp when ran on clean power and would 100% recommend it to friends with smaller systems. (And I've done just that to a few buddy's of mine)
Jerrel
2025-07-12 12:49:27
I push this amp and subs hard.... the amp will get hot but never over heats, has only shut down once after 4 hours of hard down south BASS, started right back up after 30 mins... the power knob add extra power which i mounted to sub box.... Love this new company, product is perfect..... FYI last amp I had was a 1000 watt pioneer could not push one 12 in.... this amp pushes two 12 in subs hard!!!! Update! addded 0 gauge wire on sunday, 8 gauge wire melted fuse next to battery. THANK GOD amp has safety mechs, gound was not in all the way, thought i blew amp up, restartEd car after fixing ground wire, amp cut right on, date is 1/6/23, love this company!!!! 4/20/23 Up grades speakers 12in skar and 10in alpine now it over heats and cuts off, I just restart my car, amp comes back on. But I'm thinking about another amp now......3/5/23 inputs where speakers go melted..[ in trash now] have a Zeus amp now........
Bill
2025-03-19 14:43:57
Seems to be built decent sounds alright no subsonic and the low pass filter could use more range!!
Customer
2025-03-09 11:08:33
very good product i recommend it
Customer
2025-02-28 13:03:50
Funciona muy bien para el precio real mente económica 😉
Beto
2025-01-19 14:16:38
Se calienta con 4 6X9 definitivamente les falta mejorar mucho a diferencia de un amplificador Jensen vieja escuela y definitivamente el Jensen dió mejor calidad en audio me quedé con mala experiencia BELVA
Recommended Products