Your cart is empty.
Your cart is empty.
Installation Instructions:
- Be sure to wipe clean the inside of the edge of the rearview mirror.
- Tear off the double sided adhesive protective film.
- Wait a few seconds to align the position and install it on the rearview mirror.
- After pasting, please keep pressing for about 30 seconds, focusing on the place that needs to be bent.
- Note: Keep the car clean and tidy before pasting. Avoid washing the car within 48 hours after pasting. If the temperature is below 0 degrees, please heat before pasting to ensure its stickiness.
Desiree Liang
2025-09-04 15:07:13
Im surprised. I got tempted to pimp by bum a__ old car and i saw these were nice carbon fiber material or pattern. These are so easy to install you just peel the red strip off the tape and stick it in there. It stays with little to no effort. I tested it by driving fast, braking hard, turning a lot and going over bumpy roads and they didnt budge an inch! Now- i heard these only stay on well in cooler temps. I can see why, these are more rubber or hard plastic than carbon fiber, so they can sag or bend. The weight distribution may be uneven at each tip of these so depending on gow well you positioned these and where the most airflow goes, it may slowly come off over time. I recommend every so often gently reinforcing them by pressing them harder into the pocket at the top of the side mirrors. They are tilted up and when you’re driving stand out. Theylook kinda cool- a tiny bit like wings on an airplane micro edition tho. Anyway, good product, hope it sticks.
Mad Tanker
2025-09-03 16:06:32
These stick well, they are very sturdy without being cumbersome, they are easy to size and install, and they fit the design of the vehicle.
troy morris
2025-08-19 14:28:55
Looks great but completely flawed. The adhesive is extremely poor and cannot withstand heavy rain, wind nor extended heat. Furthermore the area of the adhesive is very thin in relation to the rest of the product and therefore will not have enough surface to hold onto when the weight of the rain and wind hits it. It does not fit on small rear mirrors cause I had to trim the sides in order for it to fit.
R. Rivera
2025-08-11 11:57:41
Doesnt stick that good
Tammy McClure
2025-08-06 10:41:34
They look sweet BUT they don’t stick well. I’ve had issues with them staying on.Becareful purchasing. May loose them while driving or going through the car wash.
INNOCENT SAMUEL
2025-08-05 10:05:51
Very firm adhesive, very visible, ease of installation
Customer
2025-07-04 12:47:03
Perfect for small to medium rear view mirrors, a bit small for for a full size 2000 Ram van but it works.
Charles L. Winterberger
2025-06-01 13:52:44
Unless you are going for a specific look, they didn't help keeping my mirrors clear. I removed them shortly after putting them on.
captainmidnite2000
2025-04-11 13:43:42
So I got these carbon look visors before for my black Chevy Cruze LT 6MT, and again now on black Cadillac CTS. So not a "Blackwing," but visors are like cool little black wings. 3M stick holds well, just peel & place under the top lip of your side mirrors. Make sure to line up before sticking on the first attempt, as not to compromise the sticky strip. Function ality is, these visors act as a wee awning, to keep a brunt of the rain off your mirrors.
Terry Johnson
2025-03-19 13:16:24
Mirror visors are nice and they do a descent job.
Galvan
2025-03-18 21:13:41
Se adaptó perfecta menta a mi auto
Customer
2025-02-19 16:06:24
The material is super cheap. Only few drops of rain and the rain guard started to come off. Then, just one day of rain, light rain, the rain guards fell off. Now are useless. Please don't buy this as the material is not as shown and will not be able to handle even the lightest rainy days
Denis richer
2025-02-14 14:20:06
Excellent
Recommended Products
