Your cart is empty.
Your cart is empty.The Discovery BNC Adapter Board is intended to be used with the Analog Discovery Tool to allow the use of standard BNC terminated test leads and probes. There are BNC connectors on the Analog Discovery for each of the two oscilloscope channels. Each channel of the oscilloscope can be paired as AC or DC by adjusting the jumper located behind the channel BNC input port. In addition, the two AWG channels are also equipped with BNC connectors, and each channel can have selected either the 50 Ohm or 0 Ohm termination. This allows the user to compare the output impedance of the Analog Discovery to either standard 50 ohm test leads or connect directly to the line.
Customer
2025-05-31 11:04:17
If you want to use standard oscilloscope probes, this is your ticket. Works fine. It does not have a tab on the connector to insure the right orientation - the easiest way to confirm it’s correct is to look at the waveforms pins align with the traces going to the waveforms BNC connectors
Bach911
2025-03-07 13:02:16
I consider these a requirement for running a proper analysis.
Dulis Israel Ligua Blacio
2024-11-22 18:02:35
Buen producto y útil.
Leppla Gunter
2024-11-18 10:30:35
Was soll ich dazu schreiben . es funktioniert.
Recommended Products
$2,261.69
$ 99 .00 $99.00