Your cart is empty.
Your cart is empty.Apply For JGY-370 & A58SW31ZY DC Worm Motor.
pythan
2025-06-21 14:07:07
Headline says it all. It's just a bracket, but a good one
Mark
2025-06-07 19:11:40
It’s a fine bracket but it doesn’t fit Greartisan DC 12V 120RPM Turbo...
Patrick M. Gargano
2025-05-01 11:06:15
It is a great motor bracket and I would order it again if I had that size motor to mount. Unfortunately, I couldn't use it, due to not being the size for the motor I'm trying to mount, although it was a recommendation by Amazon to use that bracket. I'll have to look closer before ordering the next time.
Customer
2025-04-29 18:05:48
Works good
mike ferguson
2025-03-05 14:11:12
It was a little hard to get the mounting brackets to line up with the motor and get the screws in it they need to sell the connectors that go to the back side of the motor or have wires sticking out whichever is easier for them I'm not the great at soldering wires and I cannot find connectors small enough to fit on the back of the motor but if the company is reading this if you do make those connectors they connect to the back for the motor send me an email
Tim Selner
2025-01-24 13:11:04
A must have bracket useful for mounting the motor
Robert M.
2025-01-17 18:25:45
Did not fit
Mike L.
2024-11-23 15:06:18
The tolerances for the screw cutout are so tight that I was barely able to get all 4 screws in. It took about 5 attempts, and with such small hardware it was a bit of a challenge. Also, the screws are about 4mm long and the plate is 3mm thick. Very sturdy, but not great for getting good purchase with your screws. Better to source some M3 - 5mm screws elsewhere.
Recommended Products
$45.95
$ 22 .99 $22.99