Justin
2025-08-23 19:01:13
Those who complained likely didn’t follow the directions (which do require a minimum attention-to-detail). But I smoked weed with my wife and although it took a little longer than it should have, they ended up fitting perfectly and look great......and my license plate mount had been jerry rigged by whoever owned my Jeep before me, but I made it work. Make sure you prep with alcohol (I used what I had here at the house) because one prep pad wasn’t nearly enough if you want to prep the entire area.Follow the directions, take your time, and they’ll come out very well.
Customer
2025-07-12 16:31:19
This product met my expectations. In fact it exceeded my expectations. The corners fit well and the instructions were very detailed. I would highly recommend this product.
Bryan Brutherford
2025-06-21 21:51:30
these corner guards put the WACK in Bushwacker.Perhaps the ones i received were an exception since I've had good luck with other bushwacker products but they were a complete waste of time and ended up going back in the box to be returned. it appears that the hole for the fuel filler and the cut outs for the door hinges were machined after the plastic was molded and this is exactly where everything was wrong on the pair i received. The hole for the fuel filler was out of round, and was so close to the edge of the corner guard that there was a paper thin section of plastic that was floppy and deformed plus the hole was too big and left a huge gap around part of the fuel filler. The section that was supposed to fit over the door hinges on the passenger side corner was over cut on the lower hinge leaving a huge gap and under cut on the top hinge so that there was no way the door could open without just tearing the corner guard off, i could have trimmed this to fix it but there was so much else wrong that i didn't want to waste any more time.I only bought these because i thought they "looked" cool, i had no delusions that they would offer any significant protection but they just looked sloppy.
C Godfrey
2025-06-10 19:44:45
Great product, would be a little better if they went tight to the fenders. Easy to install if you follow the directions closely. Great excuse to take the top off ðŸ‘
RobT
2025-06-02 09:54:51
Another review I read here said it would need trimming for a soft top. I just assumed they didn't install properly but no. You can technically get the soft top back on without trimming but it doesn't fit quite right. It's very tight and pushes the corner guard down so the lines don't line up right. Also the cuts around the tailgate hinge aren't the best. Other than that they look good on the jeep.
Yogyakarta
2025-06-01 18:42:43
Really nice exact fit. Be sure you have removed yr tail lights and done a mock up before you remove red off the 3m tape because once they stick they ain’t coming off.
Larry S.
2025-03-24 15:21:33
Easy to install
Donnie Darko
2025-03-22 10:15:43
I really like these corners, while they may not protect the jeep from impact damage completely they give a nice aesthetic.
Customer
2025-03-10 12:54:19
Part is easy to install. Look great on.
Truthbetold
2025-01-07 16:35:15
Cleaned up the corners on my 2008 Jeep Wrangler. Easy custom fit… no fuss installation! Looks great!