Your cart is empty.
Your cart is empty.Product Description
Mark c.
2025-08-31 18:50:32
All the parts you need to properly tune your carb
george
2025-08-18 10:52:21
the jets are the wrong thread--the rods are not marked and are the wrong size and the springs are useless don't get ripped off=this is junk
VDH
2025-08-10 18:43:50
Jet threads were perfect and metering rods also worked -didn't use vacuum springs or metering rod hold springs. one star less- You do need to measure jet and metering rods because they are not stamp marked.
mark gerisch
2025-08-06 12:47:51
Got this kit to lean out my edelbrock 600 that was previously tuned for a chevy 355 with a fair sized cam. My stock 283 runs a little rich with this carb. I'll use the parts in this kit to get the mix as close to a stock calibration as it can get. We'll see how it goes....
jerry
2025-07-23 13:03:27
Parts would not fit and threads were bad
thomas hodkin
2025-06-07 15:58:23
Wish I could spec what parts sizes are in the kit
Tjs
2025-04-29 19:05:43
Springs are not colored
Tim Leonard
2025-04-23 10:07:28
Jets are actually the wrong thread size for a 1406 these are m8 when edelbrock is 5/16 24
Edson Egg Sampaio
2025-04-06 19:08:22
Bom produto
Doug Rowe
2025-03-12 12:08:26
The PARTS are NOT STAMPED just labeled in the box. SPRINGS are NOT PAINTED. It only gives you 3 selections. I had to cross reference from Edelbrock calibration chart to see what fits what. Very time consuming and annoying. But, you get what you pay for. Still worked in the long run.
Clint
2025-03-04 10:50:09
Cheap quality, don’t wast your money! But the real thing. Now
Jim
2025-02-20 17:54:21
Couldn’t use no labels on sizes
Recommended Products