Your cart is empty.
Your cart is empty. Carburetor Calibration Tuning Kit For Edelbrock CFM 1404 1405 1407 1408 1409 1411 WPA 1487 Carter AFB Carburetor
following parts:
Step Up Rod- 2
Spring - 2 1.110 * .182*.017
Spring - 2 1.280*.180*.015
Spring- 2 1.365-.175-.018
Spring- 2 1.585*.170*.017
Spring - 2 1.310*.175*.018
2 Metering Jets for the following sizes - 95, 98, 101
10 Rod Retainers
2 Metering Rods for the following
sizes- .070*.037, .073*.042, 073*.047
Spring Maximum Length:1.531 in
Spring Maximum Inside Diameter: 0.177 in
Spring Minimum Length:1.072 in
Donald Sharp
2025-08-18 14:46:03
Works well for my needs
Domenick
2025-08-09 19:58:55
Way cheaper than the edelbrock kit and works as intended. Used this kit to upgrade a 1406 to the specs of a 1405. No issues and cured the lean condition.
K J
2025-06-08 18:22:04
The parts are for the described carburetor, but the springs are hard to tell apart because they are all the same color. I am not sure if I even got the correct pairs. Three springs look the same and one odd one. Should be 5 sets of 2.
AS
2025-06-03 14:54:25
good price, fast delivery and good quality metering rod kit
stew
2025-05-29 16:49:58
Springs weren’t color coded so you can’t match them to vacuum chart, no numbers on metering rods, jets were wrong sizes. Why do I keep ordering this cheap junk, expecting it to work? Learned my lesson now I’ll order the Edelbrock kit.
Garage man
2025-04-08 10:30:00
The jets were okay, matching the secret code of subtract 300 from the stamped number. The springs were not color coded, but you can figure them out by the number of coils. The metering rods were interesting. Get your micrometer, measure them, then suss out the closes match. Could not they just label the plastic pouches? No.
It was everything I needed…
2025-02-21 11:37:23
Work on my engine.
BILL & CYNDI
2025-02-13 16:36:44
Perfect!!!
Bruce Luscombe
2025-02-07 17:52:27
Biggest issue I have is that there are no sizes indicated on parts .
Recommended Products
