Shopping Cart

Your cart is empty.

Your cart is empty.

CBW-088 Supercharger Solid Isolator Supercharger solid state isolator coupler pulley Compatible With 09-15 Cadillac CTS-V 6.2L LSA Supercharged,12-15 Camaro ZL1 6.2L LSA Supercharged

5.0 (1) Write Review
Free shipping on orders over $29.99

$21.11

$ 8 .99 $8.99

In Stock
  • √【Compatible with】:Supercharger Solid Isolator Compatible With 2009-2015 Cadillac CTS-V 6.2L LSA Supercharged，2012-2015 Camaro ZL1 6.2L LSA Supercharged.
  • √【High-Quality】:Supercharger Solid Isolator Made from Delrin (Polyoxymethylene POM) is the ideal material in parts designed to replace metal. It combines low-friction and high-wear resistance with the high strength and stiffness such applications require.
  • √【Process Upgrading】:This spring mechanism in the original isolator wears a groove in your supercharger shaft, producing debris that will cause shaft seal failure. The New Solid Isolator is a direct replacement for stock unit. The new isolator is not susceptible to failure or fatigue. It is CNC machined from a solid piece.
  • √【Perfectly Fit】:Our heavy duty isolator is not susceptible to the problems associated with the factory GM isolator.Perfect replacement for an original part.Replace #CBW-088
  • √【Note】:Please confirm that the parts are the correct ones you need before purchasing.


Product Description

Supercharger solid state isolator coupler Compatible With 2009-2015 Cadillac CTS-V 6.2L LSA Supercharged2012-2015 Camaro ZL1 6.2L LSA Supercharged

01
02

03

Perfectly Compatible

Not Original, But 100% Fit

04

Easy to Install

Perfect replacement for an original part. It is perfectly matched to the original vehicle after installation.

05

High-Quality Material

Using high-quality raw materials, more durable than the original products.


DANIEL B.
2025-01-12 12:31:10
The 6 pin holes are too small. the pins measure 7mm and the holes are substantially smaller. had to machine the faces of the isolator too as it was off a good bit and put too much pressure on the inside bearing. You will need a letter "J" drill bit as a 7mm puts too much bind on the bearings when assembling. If you don't have a mill a block of 300 grit sand paper to flatten and resize the face and back.