Your cart is empty.
Your cart is empty.Product Description
Black Rubber TR413 Valve Stems
- Black Finish
- 1.29" Overall Length (Extra Short)
- 100% Leak Tested
- EPDM Rubber construction for outstanding heat, ozone and weather resistance
- Holds up to 65psi cold pressure
Lightweight Design
Weighing in at only 8.00g (0.29oz) each, the stems are incredibly lightweight.
What's in the box?
Four (4) Circuit Performance Black Rubber Valve Stems
E_C_SSK
2025-08-22 11:16:20
perfect fit and seals nice. the finish is great and look amazing on my new wheels. used hand tools to tighten then verified tight before tire install. sealed up just fine and no issues several hundred miles later.
Rudy M
2025-08-02 10:56:44
Installed two of these on my Kawasaki, and I'm about to install the other two no my new Suzuki. Went on easily. I used some blue loctite on the 2nd (jam) nut and they held well and looked great. Black finish has held up well one year later.
M. H.
2025-07-23 20:37:16
They're aluminum and appear to be good quality. I imagine they'll last until new tires need mounted, if not longer. It's hard to mess up a valve stem. Remember, they're aluminum. Don't go tightening them down like they're a lug nut.
Michael Minor
2025-06-03 17:12:04
Worked really well
J W
2025-04-06 14:42:05
Poor quality control. One of the nuts on the back was not even threaded and the ID is too large to thread myself. Sent an email to Circuit Performance and got an auto reply that they will contact me typically within 1-2hours. It has been three days without response. I would have just returned them but the bad nut was on the last wheel I mounted. Too much of a pain to remove all the Beadlock bolts. I will just have to buy a nut to fit
Big Dave
2025-02-05 14:38:26
As short as you can get. I THINK they will be OK for my new wheels of the same brand. I have external TPMS valve caps. In a test fitting, all seem to fit OK. I need to test the access with my quick release 12V air pump. I am buying a set of slightly longer black ones to have as back up.Don't want your stems to leak? I use a light SCHMEAR of very thick silicone grease on all rubber parts. I also remove each internal core and lightly coat the tiny rubber seat. This really helps. A LOT.
Mandy L. Schenck
2025-01-29 18:51:17
Worked perfect for a 2017 Harley touring bike. Good quality and perfect fit. Looks much better than the rubber stems that came on the bike.
N. Feathers
2024-12-03 17:56:39
Rather inexpensive, but mounted these to a 1991 Miata race track car after I bought new Advanti Storm wheels. Despite hot temperatures, and a brutal environment, they hold air and have performed fine. Would buy again.
Justin
2024-12-01 17:10:40
Good quality but way to short for practice use.
Recommended Products