Your cart is empty.
Your cart is empty.This dust boot system is specifically designed for CNC machines equipped with extended collets or for those utilizing extended end mills. Constructed from a 1/2" clear Plexiglass top plate, the system features a magnetic removable base holding a transparent, flexible screen, providing clear visibility of your cutting or engraving tool in action. The magnetic base can be effortlessly removed, allowing full access for tool installation. Design to fit a the spindle/router size selected and will accept a 2-1/2 inch vacuun port. Distance from bottom of top plate to screen tips is 95mm For 4-inch Vac Port see item #B0D3MBRYGF
Customer
2025-08-11 12:49:41
I am going to give you an honest review here. unit looks goods acrylic mount with a 3d printed bottom (very thin) and the skirting is way to long clear plastic finger . I am running 1/4x1/8 x2 1/2 long bit in a makita and i have to extend the bit out so much to get their recommended 1/16 below the skirt to start ,then at 1/2 inch raise the skirt higher . The problem with extending the bit out is it chatters .and there is no raising it higher I am against the base of the rotor mount as is. Forget trying to use 1/8 genmitsu bits they are way to short. I had to clear away at some of the acrylic to get it to fit behind the rotor and all the way up to the mount. The 2 inch opening is alittle large and I needed to run a 6 wounds of tape to get the hose to stay Inside. The skirting is glued on in place and doesn't look replaceable it is also to large of a diameter around the bit. Way to large , would of been nice to have a 3inch around the bit instead of egg shaped . When cutting close to the edge you lose suction and chips go flying instead of being sucked up. I do like the added suction I am getting from it over what I did have , but it looks like I am going to have to modify it even more to get it to work. For the price I was expecting alittle more then this .. buyer beware
Doug
2025-05-20 13:23:25
Works, but a little large clunky, Could of been 3D printed better.
Recommended Products
