Your cart is empty.
Your cart is empty.Product Description
Mike S
2025-08-28 12:02:53
I had to enlarge the mounting hole due to the size, these are a good quality and highly recommended. Work great!
Gerald
2025-08-18 10:35:49
Glad I discovered this item. Table saw has been unusable for years because of broken adjuster handles. I had to drill these out to fit the shaft, but with the set screws they work fine.
RyanG
2025-08-04 13:40:10
Fit great on my craftsman Dunlap lathe. It has 2 set screw holes but didn't come with the set screws. I wasn't disappointed because I had read the other reviews saying they were missing. It's still a good value for the price. Luckily I had some laying around. They are m5-.8 thread.
B. Penn
2025-06-20 18:03:35
Bought this for a CO2 laser to help make raising and lowering the bed easier. Worked perfectly. Very solid.
GJH
2025-06-13 17:58:53
Arrived but did not include set screws for shaft. No documentation was included either on thread for set screw thread size to purchase locally. Disappointed.Edit... For those needing to know... The set screw thread for the hand wheel I received was M5 x .8, not M4 as stated in the description.
Tom V
2025-05-07 17:07:53
The machining is terrible, there is a 1/4" runout as you turn the wheel when attached to a perfectly straight shaft. Junk!The company stepped up and made it right .Thank You.
David L. Parnell
2025-03-22 11:32:00
I bought this to build a demo mechanism for my young grandson. Good quality. (I wish they supplied the set screws required or specified the thread size required so it could be ordered at the same time. ) Nonetheless, great item ! JJuust what I needed.
JD
2025-02-17 14:49:42
The one I received is close to the correct outer diameter (2.48", close enough for my application) and correct bore size (8mm), however in the picture it is shown as a through-hole, which is what I needed because the end of my shaft also has a nut on it. The one I received has a blind end. I was able to make it work, but the specific reason I purchased this one is because it looked like it would fit exactly as the original one did. If it were just a cap, I would have removed it, but the end of the bore is steel.Also removed a star for no set screws when they should reasonably be included. Seriously, they cost less than the rounding error to include.
Sebastian Szipl
2024-12-08 17:52:24
Bei mir in Verbindung mit einem ER11 Spannzangenhalter, auf einem Wabeco Bohr- und Fräsständer als Gewindeschneider für kleine Feingewinde im Einsatz.
Recommended Products