Your cart is empty.
Your cart is empty. Description:
Use removable A4988 or DRV8825 compatible stepping driver.
The extension board can be used for engraving machine or 3D printer driver.
Compatible with GRBL 0.8. Open to source firmware, converting G code command into stepping signal.
PWM spindle and direction pin, 4 shaft support (X, Y, Z, A to you can copy X, Y, Z or use pin D12 and D13 customize firmware perform complete shaft 4).
Compact design, stepping motor can connect 4 pin connectors or be soldered.
This is a set of disassembled part, and you need basic soldering skills to solder them together.
Package Included:
1 x CNC shield V3
4 x DRV8825 Stepper Motor Driver
1 x Development Board
1 x USB cable
1 x DC Power Cable
10 x Jumper Cap
20 x Limit Switch
1 x Power Switch
Mike F
2025-09-03 12:02:14
Works great
Jordon weets
2025-08-30 17:32:57
I bought and use lots of these boards. First time from these people and this one is not working properly. I have working setups so I was able to determine the shield or the uno are faulty and won't allow the steppers to move
D. Schenkel
2025-07-08 13:01:27
This has to be programmed in order to work with a small CNC. do expect to use it out of the box.
S H
2025-04-19 13:56:29
the pins on the CNC shield are soldered in at odd angles, but there aren't any surface mount components to worry about, so they're easy to fixthe arduino uno included is a generic model that for some reason tries to pass itself off as an official arduino brand board while having the most comically bootleg markings I've seen (its an open source design, its like wearing a fake moustache over a real moustache)the stepper drivers look good, but I have some TMC2209 drivers that I'll be using insteadthe switches are switches, pretty hard to mess that up (same for the jumpers)
P. Antonio
2025-02-17 12:41:01
Prodotto ok , spedizione veloce , inballaggio scarso, infatti e arrivato con qualche piccola imperfezione , ma tutto sommato ok
Mato Matijasevic
2025-01-16 13:38:38
Sehr gut!
Recommended Products
