Your cart is empty.
Your cart is empty.The pushrod is one of the most important pieces of the valve train. Pushrods not only have to be strong enough to not fail, bend or burn up at the ends, they must also match the frequency of all the rest of the parts in the valve train, as well as the RPM at which the engine will be run. Hi-Tech Pushrods feature a one-piece design from 0.080 inch wall, seamless chromemoly tubing that ensures the ultimate in strength and durability. Ends are precision formed, yielding added thickness and strength in the critical tip area, while maintaining constant wall thickness and concentricity. The pushrods are then heat treated for maximum strength to ensure compatibility with guide plates. They are OD ground for consistency and black oxide finished with length and part number laser etched on the OD for ease of identification.
jay dawson
2025-03-29 12:15:23
Seemed to be of good quality had them in my truck for a few weeks now no problems yet.
Ray Karner
2025-03-26 15:49:14
These are nice pushrods but the intake rods are .050 too short if using with a high lift cam or in a 6.1. They need to be 6.650. Comp cams really needs to address this.
Akram Qaud
2025-03-22 11:07:16
good
Anonymous
2025-03-01 10:09:43
Did not fit my truck (my fault) but I requested a refund, returned the product, and still haven’t gotten the money back weeks later.
Justin
2025-02-12 11:39:38
Item as described did engine rebuild used original rods they immediately bent put these in trucks been running great ever cents
Recommended Products
$183.95
$ 76 .99 $76.99
$183.95
$ 72 .99 $72.99
$144.95
$ 65 .99 $65.99