Your cart is empty.
Your cart is empty. Full Alternator Wire Kit For Powerstroke 6.0L/7.3L F Series
Part # DPS-FULL
Full Wiring Upgrade Kit For Use with High Output Alternators. Some Minor Modification required for use on 99-03 Ford 7.3L Powerstroke Diesel Trucks This kit is a must have for trucks with High Output Alternators. It is designed to work with single alternator systems, will not work with dual alternator trucks. Long Red Wire is 3/0 Gauge With 1/4 Lugs On Each End Medium Red Wire is 1/0 Gauge With 5/16 Lugs On Each End Short Red Wire is 1/0 Gauge With 1/4 & 5/16 Lugs On Each End Long Black Wire is 1/0 Gauge With 3/8 & 5/16 Lugs On Each End Short Black Wire is 1/0 Gauge With 3/8 Lugs On Each End
Hal Hansen
2025-08-04 15:02:04
The full setup was a bit tricky, but that is all because I am spatially challenged. If you draw it out, test your layout, and have all your tools setup appropriately, you will be able to install this new kit very easily and quickly. However, that is provided your truck lets you get all your bolts and leads on without too much fuss!I would recommend going through with a new set of battery leads. This would great help for everything onto your batteries.
Ryan R.
2025-07-21 11:20:41
I used this for my 6.0 powerstroke when upgrading the alternator to 240amps. This kit is absolutely legit, blew me away compared to the other guys and their price vs this. As far as I can tell, it's the exact same kit. If it's not, well I can't tell.. Did not come with instructions but downloaded via the other guys websites. Even the ground bolt to the engine was the correct thread. When putting across the radiator and under the supports I didn't have shrink wrap but used electrical tape to protect against the supports. This is a must, the supports will start to cut into the cable. Drove it for a day and noticed the chaffing and immediately wrapped the areas in electrical tape. Use what you have. Been using this for a couple months and it's perfect. 10/10
Taylor
2025-07-04 19:28:35
I inquired about wire type and if it was OFC copper. The gentlemen said he was unfamiliar with that term. The product is for sure large strand copper wire. I ended up buying tinned OFC from KNUKONCEPTS. I did two ford 6.0 trucks big 3 upgrade with 1/0 and 4/0 wire (power/ground) for 350$. Ended up being a better deal than this product was.
Customer
2025-06-26 16:02:10
Worked great for my 2000 F250 7.3.
Racerdad725
2025-05-27 16:41:35
Was as described would buy from again
KM5506
2025-05-16 14:40:54
They said these wires are the exact length for my truck but I couldn't find the ground wires where they end.
Hal Hansen
2025-04-24 10:06:11
The full setup was a bit tricky, but that is all because I am spatially challenged. If you draw it out, test your layout, and have all your tools setup appropriately, you will be able to install this new kit very easily and quickly. However, that is provided your truck lets you get all your bolts and leads on without too much fuss!I would recommend going through with a new set of battery leads. This would great help for everything onto your batteries.
Ryan R.
2025-03-16 10:57:06
I used this for my 6.0 powerstroke when upgrading the alternator to 240amps. This kit is absolutely legit, blew me away compared to the other guys and their price vs this. As far as I can tell, it's the exact same kit. If it's not, well I can't tell.. Did not come with instructions but downloaded via the other guys websites. Even the ground bolt to the engine was the correct thread. When putting across the radiator and under the supports I didn't have shrink wrap but used electrical tape to protect against the supports. This is a must, the supports will start to cut into the cable. Drove it for a day and noticed the chaffing and immediately wrapped the areas in electrical tape. Use what you have. Been using this for a couple months and it's perfect. 10/10
Taylor
2025-03-09 14:34:22
I inquired about wire type and if it was OFC copper. The gentlemen said he was unfamiliar with that term. The product is for sure large strand copper wire. I ended up buying tinned OFC from KNUKONCEPTS. I did two ford 6.0 trucks big 3 upgrade with 1/0 and 4/0 wire (power/ground) for 350$. Ended up being a better deal than this product was.
Customer
2025-03-07 13:25:23
Worked great for my 2000 F250 7.3.
Racerdad725
2025-02-21 10:05:40
Was as described would buy from again
KM5506
2025-02-20 18:12:59
They said these wires are the exact length for my truck but I couldn't find the ground wires where they end.
Recommended Products
