Shopping Cart

Your cart is empty.

Your cart is empty.

DC 12V 4 Channel Multifunction Cycle Delay Timer Relay Module and Timing Loop Interlock Self-Locking Momentary Bistable Monostable (1)

5.0 Write Review
Free shipping on orders over $29.99

$20.99

$ 10 .99 $10.99

In Stock

1.NumberofItems:4


About this item

  • 4 channel relay,each channel independently triggered independent delay, do not interfere with each other.
  • 6 kinds of functional modules, each functional module has three sub-modes (no cycle, 2-99 cycle, always cycle).
  • Input optical isolation.
  • Power anti-reverse diode.
  • High Q value SMD electrolytic capacitors.


Product Features:

1. Longest delay time : 00h:00m:01s - 99h:59m:59s

2. 4 channel relay,each channel independently triggered independent delay, do not interfere with each other.

3. 6 kinds of functional modules, each functional module has three sub-modes (no cycle, 2-99 cycle, always cycle).

4. Input optical isolation.

5. Power anti-reverse diode.

6. High Q value SMD electrolytic capacitors.

Product Specifications:

1. Operating voltage: power supply 1,DC 6.5-25V; power supply 2,DC 5V

2. Operating Current(DC 12V): Standby current (all relays closed) 16MA, 1 relay open 50MA, 2 relays open 82MA, 3 relays open 115MA, 4 relays open 150MA

3. Size: 80x66x20

4. Weight : 75g

5. Relay maximum load capacity: DC 1-100V/6A; AC 85-265V/5A

User Instructions:

Short press: press key time is less than 2 seconds;

Long press: press key time more than 2 seconds;

Status: working status , set status, power-saving status.

working status : start work after powering. Displays the remaining time of 1 channel, the parameters can be displayed the "channel select" to set;

Set status: short press the "SET" key to enter "channel select" Status. Short press "OK" button to exit the setting;

power-saving status: in this Status,digital tubes donot display,and other features work correctly. Long press "OK" button after 5 seconds to enter power-saving status, press again "OK" button for 5 seconds or re-power to exit power-saving status.

Factory settings: press and hold "++" and "--" two button for 3 seconds, to restore factory settings, and the digital tube will turn open . After re-power , will run default parameters.