Your cart is empty.
Your cart is empty.Product Description
Setting description:
Power on,display the measured current; (if the measured current terminal is none, the LED digitswill pulse)
Press K1 for the second time(for over 1s to prevent misoperation), the screen shows: P11, k2 adjusts mode, K3 adjusts functionPress K1 for the second time, the screen flashes: 0.05,means the threshold I1 is 0.05A,K2 increasesI1, K3 increases I1Press K1 for the third time, the screen flashes: 0.10,means the threshold I2 is 0.1A; K2 increases I2, K3 increases I2Press K1 for the fourth time, thescreen shows themeasured current , entersthe standby stateLong press K2 or K3 in standby state to fine-tune the errorof the measured current
AJ
2025-02-20 09:05:59
It works and is fairly simple to setup. The most disappointing thing and almost a fatal flaw is that the coil’s current of its relay is sensed by the load sensor and really messes up the threshold settings. If the current of the device on the load is not enough greater than the onboard coil’s current, you are kind of screwed
Recommended Products
$390.99
$ 99 .00 $99.00
$47.00
$ 20 .99 $20.99
$18.24
$ 8 .99 $8.99