Your cart is empty.
Your cart is empty.Sue
2025-08-30 15:11:28
Using this controller to drive a high output fuel pump from a 24kHz PWM control signal is 24kHz.35amp inrush on startup, and 12-18 amp continuous operation, the driver is going strong and within reasonable thermal limits. Nice value for the cost.
R. Monsen
2025-08-23 20:18:07
I connected up both channels. One uses about 5A, the other can draw up to 30A. The 5A channel works perfectly. The 30A channel burned out that side of the H Bridge immediately.
VL
2025-07-17 20:01:26
The media could not be loaded.
Kyle
2025-06-25 16:44:27
This DC 5-12V Dual Channel H Bridge Motor Driver Board is a fantastic choice for controlling DC motors in robotics projects. The dual-channel design allows you to control two motors independently, and the wide voltage range (5-12V) makes it compatible with a variety of motors. The 30A current capacity is impressive, providing ample power for even demanding applications. I've been using it to control the motors on a small robot, and it's been working flawlessly, providing smooth and precise control.
Zidar
2025-02-26 21:32:26
Had some trouble getting 3.3v PWM from my ESP32 to register on the driver but I fixed it by using the MCPWM library pre-built into the ESP32 and setting the PWM frequency to 24000Hz. Unfortunately, literally none of the screw terminals worked so I just clipped them off and soldered my own connections. Other than that the product works fine; did not test the 30A claim.
Client d'
2025-02-08 18:15:40
Bon produit , livraison rapide .
Nick
2025-01-09 10:29:52
Works well, does its intended job.
Recommended Products