Shopping Cart

Your cart is empty.

Your cart is empty.

Delphi GN10571 Pencil Ignition Coil

Free shipping on orders over $29.99

$23.30

$ 10 .99 $10.99

In Stock

About this item

  • Delphi uses winding process techniques to control the length of wire between adjacent windings. That’s important because more length results in greater voltage differences, which in turn create more pressure that could break down the insulation and wire coating.
  • Delphi's ignition coils are engineered to Original Equipment specifications
  • Delphi's ignition coils are designed with proven materials, such as high quality wires and wire coating that resists the cracks, pin holes and imperfections that most often lead to failure issues
  • Epoxy vacuum techniques reduce air bubbles in the epoxy, because having fewer air bubbles increases the epoxy's insulation quality and reduces the chances of energy punch-through failures
  • Delphi's coils are designed and endurance tested to resist the common stresses that cause failure


Delphi ignition coils are designed to operate as part of an integral engine management system to insert power into spark plugs and ensure fast starts, consistent engine performance and optimized fuel efficiency.


Cedric Wiley
2025-09-06 16:26:41
Works well for 2011 BMW 750i … Car engine runs much smoother
jordan
2025-08-26 16:08:07
I replaced all 6 of my ignition coils with these. Quality of the coils are very good I have had no issues at all with mine. Running over 10,000 miles on them so far.
MIKE
2025-08-23 17:52:18
Tuned or stock, this is a high quality coil by a reputable company! Your BMW will love it.CLEAN ALL OIL OFF OF YOUR CYLINDER HEAD AND SPARK PLUGS! Of you have a leaking valve cover or you will need new plugs again and coils later.
Victoria Donahue (Vicki)
2025-08-16 17:21:01
Great price for factory used part
The Pirate
2025-08-06 09:57:14
Normally a stick coil is pretty easy to replace, on BMW 528I it was a little bit of a pain to get to the rear coils but not a coil fault. The coils were a bit more of an issue than they should have been to get the stock clip plug in. Take not when doing so. You may think you have it plugged in but it's not making full contact. Note spacing when removing. Once installed, operation is good... No issues
Margaret Farnum
2025-08-05 17:33:23
I like that Amazon finds the right part for your car. This part was a perfect fit for our 2008 BMW 528i but make sure you put in either your VIN or your license plate for that particular car. Car is running so much better.
Michael jaber
2025-07-13 15:09:25
Fraction of the price at a dealership , 2014 X5 BMW
Darion F Jenkins
2025-07-03 16:32:18
Awesome
Lloyd E.N Bartholomew
2025-06-25 18:58:28
Liked it. Used on BMW 545i; 2003 Trailblazer for lower body panel replacing rotted out components.New panels needed the rivnuts.
Van Berna
2025-06-23 17:16:25
Excelente bobina aplica para peugeot 508 1.6T siendo las originales
angus
2025-04-21 17:04:35
Direct replacement of the original one.My 2011 X3 35i ran jerky when accelerating then the "Maximum drivetrain output not available" showed up, OBD code P0306. After eliminate not spark plug issue, replacing the coil pack on cylinder #6 resolved problem.
Aury 😎🎶🎧🎸
2025-01-28 18:03:01
Solicité tres bobinas para una BMW X1, de esas tres, una me llegó usada, quemada y no correspondía al número de serie de la pieza; es diferente a las otras dos.
HBP
2025-01-11 18:08:28
Quality, value for money
Recommended Products