Your cart is empty.
Your cart is empty. Color:40 pcs connectors+4 pcs Article in parallel+4 pcs Digital identification+40 pcs screw
UOHGDPY the patented design, different from the ordinary rail connector, does not require the tedious tightening of screws, just insert the guide terminal into the 35mm iron and aluminum DIN guide, lift the orange clip,
insert the wire into the hole until you feel the resistance, then lower the orange lever and complete the operation, saving 70% of the operation time.
Specifications:
➤Terminal Blocks UK5N: It can connect two conductors with ease, even large conductor cross sections are not a problem. Can be used on DIN Rail 35mm, steel or aluminum.
Material: Nylon PA66 Housing + Brass Metal Bodies Rated voltage: 250V. Rated current: 32A Solid Wire (AWG/mm²): 28-12, IEC 0.08-4, Flexible Wire(AWG/mm²): 20-14, IEC 0.5-2.5.
➤End Stopper Bracket: Terminal fixed component mark clamp and marl strip could be blocked onto it to mark it, additionally, it could be used as fixed component to terminal row's termination
➤Package Included: 40 x Terminal Blocks 4 x Connection Bar 4 x Digital Identification 40 x Screws 1 x Transparent Storage Box.
Warm note:
1. Due to the light and screen difference, the item's color may be slightly different from the pictures.
2. Please allow 0.5-2 cm differences due to manual measurement.
How to use the wire nuts:
1.Strip off the housing of wires to 0.35-0.40inch
2.Push the orange levers to 90°,and make sure that wires are plugged into the end.
3. put the levers back.
40 pcs screw
jhs
2025-06-29 15:28:22
These things are great. Super easy to set up an interconnection area. I used to use barrier strips. This is my new go to solution.
Robert C. Mckinney
2025-06-16 11:17:32
These are so easy to utilize. I don’t use lever lock type connectors for anything more than low current controls. I did use the tie bar to create low current distribution. Which this works so well for.
Joshua Deaver
2025-05-20 13:23:58
Be careful when unclipping from the Din rail. I have broke several of the them removing them.
John Dever III
2025-05-19 13:38:00
Quality product, worked great.
Liangyan Liu
2025-05-14 14:50:11
it is every easy to connect the wire
Travelah
2025-04-28 13:17:29
Using these to distribute power on a test control panel at home. They fit firmly on DIN rail, not loose nor do they wiggle around so no other parts are needed to keep them in place.
Carlan Wray
2025-04-24 11:02:39
The media could not be loaded.
Melvin N.
2025-02-03 19:42:52
Repetitive connections,places where screwdrivers are unsafe,I used mine to distribute power to and from the inverter in my truck.Now I need a bigger inverter.
Recommended Products
