Your cart is empty.
Your cart is empty.Product Description
Completely weather resistant and waterproof, and able to work in almost any condition, this advanced access control system is easy to install, programmable, Protect personal property, businesses, or off-limit areas.
Important Notice:
Compatible EM standard card (Can't support some encrypted cards,such as HID, Cobra, APCiK, etc)
Important Notice:
- It's a wired keypad, for garage door/sliding door openers, please make sure your garage door/sliding door openers is compatible with the keypad.
- If your garage door/sliding door openers has a wired wall push button wiring port, supports run by wired wall push button, then it's compatible with the keypad.
- The wired keypad can be used with most third party garage door/gate openers or swing/sliding door openers, whose control board accepts “normally open dry contact” signal, powered by the openers control board or powered by an external DC 12V-24V power supply control.
Specifications:
- Input Voltage :DC 12V
- Frequency: 125khz
- User Capacity : 2000
- Card Reading Distance : 1 ~ 6 cm
- Operation Temperature: -45℃~60℃ / -49℉~140℉
- Input Current : Standby : < 30mA (not including attached devices)
Package includes:
- 1 x Metal Access Control
- 5 x 125kHz RFID Keyfobs
- 1 x Installation Fixed Label
- 1 x Installation Kit
- 1 x User Manual
Features:
- Strong Zinc Alloy Electroplated anti-vandal case, IP68 Waterproof, high security.
- 125kHz RFID Proximity ID Token Tag Key keyfobs for Access Control.
- Support 2000 standard users, Supports ID Card, Password, ID Card + Password, Can add user and delete user as your requirement.
- Full programming from the keypad, Built-in proximity card reader, Built-in keypad for PIN code entry, Backlight keys.
- With lock relay output, Lock output current short circuit protection, Very low power consumption.
- Secure / normal Mode, NO / NC output, Build-in buzzer, Built-in light dependent resistor (LDR) for anti tamper.
- Red, Yellow and Green LEDs display the working status.
RFID Keyfobs:
- Works as a regular 125KHz RFID
- Card type: Standard EM card
- Chip: Tk4100
- Compatible with standard EM ID access devices or ID reader
- Contactless transmission of data and supply energy
- Card material: PVC
- Detection distance: 2-10mm
- Read only, not HID card, can not be programmed, not rewritable
- Each card pre-programmed with a unique ID number, first 10 digitals are printed on the card
- Compatible with other universal 125kHz tags like EM4100/4102, Suitable for 125kHz RFID proximity access control system and ID management system
Backlight Keypad Feature
Access control keypad with blue backlight features keys, you can see the keypad numbers at night or in the dark outside the home.
Light indication for different modes; Red light stands for Enter into programming mode;Yellow light for in the programming mode;Green light for Operation successful mode.
Outdoor Waterproof Design
The access control keypad with strong zinc alloy, impact resistance and wear resistance, anti-vandal and weatherproof.
Epoxy to completely encapsulated, Back potting treatment, effective against water ingress, heat, corrosion. Suitable for mounting either indoor or outdoor.
Tamper Alarm Function
Built in buzzer and light dependent resistor (LDR) for anti tamper.
Alloy Electroplated anti-vandal case, Anti explosion and pry, which is durable to use.
Buzzer alarm when disassembling the access control keypad.
Large Capacity
- Easy install, supporting 2,000 users
- Rugged zinc alloy suited for outdoor use
- User modification password. It is easy for Users can revise the door password
- Provided with a WG26 interface and door bell button
3 Ways Access
- Support Card, Password, Card + Password 3 access ways.
- After card is lost, usable keyboard delete card, thoroughly eliminate safety lapses.
- Support releases an electric door lock.
- Set door relay strike time 0-99 seconds.
Easy to use
- Self contained keyless entry great for hospitals, airports, office buildings and other commercial locations
- Sealed Housing Weatherproof Stand-Alone Keypad
- Suitable for detached garage; security gate; man gate;vehicles gate;gated entrance;office;household
- RFID Keypad Widely used in home, office, residential area and other public places.
IMPORTANT NOTE:
It's a wired keypad, for garage door/sliding door openers, please make sure your garage door/sliding door openers is compatible with the keypad.
If your garage door/sliding door openers has a wired wall push button wiring port, supports run by wired wall push button, then it's compatible with the keypad.
Installation:
- Remove the back cover from the keypad using the supplied special screw driver
- Drill 2 holes on the wall for the Self tapping screws and 1 hole for the cable
- Put the supplied rubber bungs into the 2 holes
- Fix the back cover firmly on the wall with 2 Self tapping screws
- Thread the cable through the cable hole
- Attach the keypad to the back cover
Please note that "exit button", "electric lock", "DC 12V power supply", "Remote control"are not included in this package, please kindly refer to our store for all available accessories for Access Control.
Derek Macy
2025-08-31 12:56:48
Easy to install and program but you will need a striker lock or magnet lock to control the door. I just used punch code and skipped the key fobs. When inside I put a hidden light switch to interrupt the 12 volt signal to leave door unlocked....end of the day, flip switch to reconnect power and the door locks for the night.
Trevor E.
2025-08-06 15:20:57
Keypad is durable and easy configuration
Scott Bradley
2025-07-26 20:35:21
Purchase 10 of these keypads in the last year eight of them have numbers that are no longer lit up.
Dave Carrington
2025-05-21 17:37:02
Havent installed yet, but looks quality
David Malek
2025-05-01 11:34:12
What you'll need for this is better instructions from the manufacturer, either that or you'll need to hire an electrician who knows what he or she is doing. This is a very well-made item hefty metal box with fobs for easy access. It's a "pro" item that if you use it for your home will be a very nice addition.If the manufacturer could post a video of the installation of this box using a garage door opener that would be the best thing they could do. That would get the 5 stars, but I contacted them and asked for a video but they sent me a pdf of the same booklet that came with the keypad.
Roi azulay
2025-03-31 15:24:14
good product
Off-Grid Family
2025-01-20 19:27:50
I'm using this keypad to interrupt the power on a 350# magnetic door lock on our solar shed. This is primarily to make sure no kids or random folks wander into it give it's our 'power' station essentially. It works great. The install is simple to setup, I was able to easily mount it outside next to the door and run the line in to connect to the power as well as the door lock. The keypad can be used as an interrupt so that it normally lets the power continue to the magnet but when you unlock it this disables for a short bit so you can open the door. If I need to disable the lock for a time I have a rocker switch inside the door that I can turn cut the power to the lock.I like that I can put in a couple codes (in case I forget one) and it also works with a fob so we can just have the fob on our keys and in we go in a hurry.Overall great addition to add a bit of security without adding too much complexity.
Recommended Products
$119.00
$ 53 .99 $53.99