Your cart is empty.
Your cart is empty.This exhaust flange stud and nut are designed to match the fit and function of the original hardware on specified vehicles. Made of quality materials, this hardware is engineered for reliable performance.
mk
2025-09-02 16:47:56
These studs are correct for a 2000 Ford ranger 3.0 flex fuel. The stud installs on the exhaust manifold and then bolts to the exhaust crossover pipe. The old studs required a torch to get out but if you can save the threads in the manifold these will install as they are the correct size. Quality was good in my case. Note the box came with two studs and two nuts so you will need one set for each side or 2 products total for both sides.
Charles Howard
2025-08-19 17:04:59
Fits 85 Bronco 2 2.8l exhaust flange. Holes are too small on the exhaust flange pipe side, will need to drill them larger. The bolts are holding with no leaks, difficult to start but once tighten its in place.
dan
2025-07-26 12:17:20
Not sure why, but the nut is super hard to tighten on these as others have said. Had to use an impact and hope they wouldn't snap. Definitely the threads are the issue. The Nuts would go on the old studs pretty easily. But, they do their job
bryson28713
2025-07-25 13:58:31
Yes, they tighten hard for a reason. That reason is so it doesn’t come unthreaded. These studs are use once and replace. Did not use for their intended purpose, so can’t comment on fit.
GARY M.
2025-07-05 12:46:30
Great fit and easy installation
KEVIN H
2025-07-01 18:24:17
Trash! The nuts they supplied won't even thread onto studs. Studs needed to be chased, both ends. Diameter of studs larger than specs making chasing very hard. Don't waste money on these! Poor manufacturing quality. Total junk!
Meghan Ebbitt
2025-05-24 18:41:23
These Dorman 03129 dont fit 2006 mustang gt. Dorman 03131 fits my 06 mustang gt. Amazon vehicle fit checker isn't accurate.
Michael Y.
2025-04-17 16:57:48
Great fit
ibajs2
2025-03-19 11:16:34
Despite Amazon fitment tool's suggestion, these do not fit my 2006 Mustang GT. However, Dorman does not seem to have hardware that does fit so I drilled and tapped my exhaust flange to make this fit. Might be more than the average DIYer is ready for.
Kev
2025-02-24 13:20:25
Not the same tread at all, at least too fit original manifold.I think these ones are for aftermarket.Need to redo a treads and built a flange for it because nothing fit.
braden t
2025-02-18 18:43:22
fyi this is not the right fit for 1999-2004 mustangs even though it says it is
Recommended Products
$19.00
$ 7 .99 $7.99
$28.04
$ 11 .99 $11.99