Your cart is empty.
Your cart is empty.This suspension control arm bumper is precision-engineered and rigorously tested to provide reliable replacement for the original equipment on specific vehicles.
George Robards
2025-08-12 10:14:25
I ordered a set of these at the same time. For what ever reason, one was shipped via prime and the other USPS. WTF. At any rate, the part was correct.I raised the truck using a floor jack under the lower control arm, raising the truck just enough remove the tire/wheel. Used a 9/16 ratchet box end. Took maybe 5 minutes tops. If you raise the truck via a frame lift, the upper control arm may block your access to the bumper's nut. Pretty easy, just take your time.
KatsRule
2025-06-16 11:24:30
This product worked well, but as in other reviews they stated they had to adjust the pinthat hold it in place while you tighten the nut.There is a small pin punched into the top to assure the product does not spin while tightening the nut,and the pin is a bit slumped over, not straight up and down.. I too had to take a large screwdriver and a hammer to straighten the pin, but it was a very small task, and the product then fit perfectly.Easy to install, in an easier access part of the A Frame on the top A Frame, just reach in and unboltthe old one, and slip in the new one....all this after taking the tire off as well before you start .Great product.
JON PATZER
2025-06-04 12:37:59
These will hopefully be an improvement in durability oven the originals. A problem for my vehicle was that the locating tab was not quite perpendicular and fell a little short of the factory mounting slot. Bending the tab up a little farther allowed it to fit.
James P
2025-04-29 12:38:50
Product was an easy swap, and has held up well since purchase
ernie elliott
2025-04-16 16:51:28
they work
RC1057
2025-04-13 11:30:29
Fit perfectly and looks durable.
Chris
2025-04-02 09:17:44
Good part but the alignment tab that is punched out isn’t very precise and needs adjustment to fit the control arm. Had to send one back because it was so badly done it couldn’t be adjusted. Easy swap out from Amazon though.
Brandon Nierenhausen
2025-03-30 17:57:06
These are fantastic. The ones on my 2000 Bravada were almost completely destroyed. When i installed these they made a huge difference over bumps it was awesome! The only negative was trying to install them. If you want to make it easier just pull old bumper out on the vehicle using a screw driver but leave the frame it was in bolted to the vehicle. Then just pull the new bumper out of its frame and lube it a little bit and slide it in the old frame that is already on the vehicle. It takes a little elbow grease but they will fit.
Yannick Brouillard
2025-03-16 11:35:57
Good
Tommy ross
2025-03-06 14:56:21
Excellente qualité de pièces va a merveille
James wubbolt
2025-02-04 21:01:33
Perfect fit
Craz Cdn
2024-12-30 14:49:26
Fits well like it should
levis lefebvre
2024-12-29 17:09:45
perfect fit
Recommended Products
