Your cart is empty.
Your cart is empty.Make better electrical repairs and accessory installations with this pigtail connector. Designed for a clean appearance when installed, it features weatherproof terminals and a locking tab for a reliable quick disconnect electrical connection.
Aadonis
2025-06-09 14:31:41
Fit just fine , the wires are pretty long for easy splicing.
Elijah C.
2025-06-03 16:46:06
well had to depin it and remove the wires from the pigtail so that I could replace my original with it on my vehicle, but it is sturdy and did work solved the problem and not too labor intensive. 5 stars seems fair.
Robert
2025-05-16 11:19:00
wired in and works great. old pig tail was broken
Michael N.
2025-05-06 17:19:54
Sleep o meter works again
van
2025-05-05 12:11:59
Replaced a old connector that had broken tabs.
John S.
2025-04-16 16:20:25
The part in the photograph has a lip at the end where the wires come out. The connector I received does not. This would work great on a Mustang application. On a Ford truck it requires that end for the rubber boot to attach to keep water out. I would not recommend it if you're putting it on a rear differential in a Ford truck. Buy the Motorcraft connector. I put this one in stock for the Mustang collection
Mr. Baker
2025-03-23 15:50:37
1995 f250 7.3 My abs was blinking on the dash and this fixed my issue along with buying a new ABS to differential speed sensor. Blinking gone!!!
Tanya Algee
2025-02-20 09:04:23
Easy install and performing perfectly.
FaceDeAce
2024-12-27 14:12:26
Working through issues on a 2003 F150. The ABS light is on. Pulled codes, showed rear sensor fault. Under the truck the sensor the axle is good but the wire end connector on truck is missing with frayed wires exposed. This pig tail was a perfect fit onto the sensor in the axle. Spliced it into the frayed wire ends on the truck. ABS fault cleared, everything is now working fine. An easy fix, the right fix.
Edward Twin
2024-12-23 14:08:02
Wrong part for abs as it says it is.
Recommended Products
