Your cart is empty.
Your cart is empty.Restore proper fuel gauge readings with Dorman's Fuel Tank Sending Unit. All units include the necessary installation hardware for a bolt- off/bolt on solution. Since this part is direct replacement, the exact fit adds another layer of convenience. Vehicle model years this part fits: Honda Odyssey: 2008, 2009, 2010
Peter Robberson
2025-08-18 11:39:22
We like that this product is soft and pliable. All of the details lined up perfectly to replace the previous cracked intake.
greg wright-crowe
2025-08-17 13:55:17
just like OEM
William O.
2025-07-21 13:56:20
This part looks and works like OEM, and for a fraction of the price. Only took minutes to install, saved $200 from going to the dealership.
Scott Mattaliano
2025-07-09 14:50:52
If you use clamps it comes with it makes tightening the clamp at the throttle body difficult. The clamp is keyed so you can't just flip it to correct. Not really a big deal but extra work if you bury the fastener behind the intake.Perfect fit super easy to install. maybe 3 minutes for myself..average person 5-10 minutes.
Maksi Maksi
2025-06-28 11:23:54
Super
Sean
2025-05-25 20:37:31
I had not one issue fitting this hose on my van. Slipped on relatively easy with some wiggling and clamps were all oriented the right way. Think it took 5 mins. Super easy replacement
Lop3z13
2025-05-04 09:49:41
Fit perfectly
T-rex
2025-05-02 18:35:54
This air intake hose fit perfectly and went on just like OEM, but at a fraction of the cost.
Wendy Bell
2025-04-03 17:44:11
This part is half the price of the OEM (which doesn't include the clamps) and includes clamps which are equal to or better than OEM. It seems to be good quality rubber and has all the special alignment mouldings exactly as OEM. I sprayed penetrating fluid (Rust Check) the day before and disassembly was easy after I disconnected the air filter cover. Note you need to take the shroud off the engine to easily access the engine side clamp but that's only a half twist on two plastic screws. A dab of silicone lubricant on the new rubber and everything slide into place easily. Biggest challenge was disconnecting the small diameter metal tube on the side. I think it's part of the EGR system? It's inserted to a depth over an inch so you need to be cautious about not twisting too hard for removal. The two ends need to be free first to avoid pulling the small tube too far back and straining other joints. Only did a test drive so far, but set no codes, seems to be running smoother, didn't catch fire or explode. Two thumbs up. Honda dealer installed would have been close to $300, I took 45 minutes, got my hands dirty, fixed it myself and saved $250.
carlos
2025-03-27 15:15:39
I installed it on my 2010 Honda Odyssey. Easy to install and fit perfectly.
Thanh B
2025-02-20 19:03:40
Bought it for my 2008 honda Odyssey, working great. Only thing is the clamp faces the other way, i reused my old clamp
Jaykumar
2025-01-22 13:28:09
Ok quality but value for money
ruq2011
2024-11-17 16:29:57
Perfect fit for my 2010 honda odyssey just like the oem, the clamps in the right way all Good.
Recommended Products
$17.99
$ 7 .99 $7.99