Your cart is empty.
Your cart is empty.This replacement fuel line is made to safely transfer fuel and endure in tough underhood and undercar conditions.
Gmack
2025-08-29 21:06:38
Super easy install fits nicely no leaks alot easier to work with then hard lines. Cheap fix. Not super flexible but they have some play and they perform nice
widget
2025-07-26 17:44:17
I apparently rotated the rear fuel line on my 99 Mustang 4.6L so that it got too close to the EGR valve... which ultimately caused a leak.The dealership didn't have anything but rubber hose. Ebay didn't have any used of the same part design and I wanted this to remain looking relatively stock. So, I picked up this line and a crimp kit.Since my stock plastic fuel line was molded, I had to figure out how to shape this line without kinking it. After some trial, error, and frustration... I found that cutting the end of an old spark plug wire off and using it as a mandrel worked so well that I couldn't kink the line if I tried. I slid the plug wire inside the hose and carefully used a tea light candle on the side of the line that needed stretched... made the bend and held it till it cooled (a damp towel was helpful).It took a while, but I ended up with a relatively well formed line that would navigate the engine. I ran a high temperature heat shrink over the tube, as an extra layer of protection, and pulled the plug wire out. I put a clamp on the metal barbs coming off the fuel rails, heated up each end and the metal barbed tube, and it slid on well. I put the clamps on (just as extra precaution) and shrunk the heat shrink over the entire assembly.With so much trial and error, this was a much bigger project than I would have thought it would be... but this tubing did exactly what it was supposed to do.
Stepside
2025-07-19 15:20:16
Although amazon sat on this order for over a week before shipping, when I finally received it, the fuel line was an easy installation. I used both compression fitting & inline quick connector (similar to "sharkbite" plumbing connector)Both connectors worked fine for a successful leak free installation.Note: make sure fuel line is cut 'square' ie even around circumference.
william g mccafferty
2025-07-09 12:23:50
It worked but it took work, i used the plumbing flare tool resting on top of a vise holding the fuel line. For the straight end i fit a socket over the outside of it and hammered down, no heat it will mess up, little dish detergent, For pressing the angle connector on i used 3/4 inch PVC plumbing tubing and carved a U it to slide over it sideways and hammer it down. After i molded the line bends by lying the line on top of plywood next to the old one and used u shaped wire holders nailed down lightly and shaped it to the old , then used the heat gun and left it for a while : )
Dan S
2025-05-22 12:38:43
This is perfect for a 2002 Saturn L100 fuel tank output from the fuel pump to the filter (fuel RETURN to the tank requires the smaller 5/16 quick-connect). Also purchase Dorman's 3/8 quick connects, plus 5/16 quick-connects and nylon hose for the return port on the pump.Bend the nylon fuel hose with a heat gun, put a spark-plug sized wire inside the hose to prevent kinking, and heat the hose just enough to bend it to the correct shape of the original hose. Heat the end and use a vice, a brake-line flaring tool & c-clamp to push the adapter into the hose.
Eliu Griego
2025-05-13 10:21:17
Was as described
m3dra
2025-02-15 14:22:11
Lots videos on YouTube how to install fittings. Line comes roll so is going to be a little hard to run under the vehicle.
Jared Wilson
2025-02-04 12:49:23
This may not be a big deal to many, but this is 2 inches shy of a full 10 feet.
MasterTov
2025-01-18 18:13:46
good
6VSparkigniter
2025-01-13 20:54:20
Much thicker wall than the first "no-name" stuff I received in a Dorman bag. This 10' coil also had crimps from the heavy zip ties used to minimize the coils size (for shipping I assume). A little heat & I was able to press out most of the crimps. Real answer would be to coil and package in a larger 12-14" circle.
William trenholm
2024-12-19 18:10:39
Hose broke
Recommended Products
