Your cart is empty.
Your cart is empty.Drill America Qualtech Drill chuck arbor. R8 shank to #33 Jacobs taper.
Robert
2025-08-05 16:37:14
Quite pleased measured @ .0008 run out, very nice arbor.
Jerry Robison
2025-07-24 13:34:54
Nice result, but had to work on my technique.Adapter was first cleaned with a degreaser aka brake cleaner, then tossed into the freezer.Chuck was also degreased, on the inside, and tossed into an oven at 200 degrees.I merged the two using a 2lb hammer, however this caused the end to bulge at the top making it a tight fit into the mill.I corrected this and decided my 10 ton press would get the job in the future.Update: Had to go back in to correct a run-out problem. Took 9 tons to seat to the shoulder and this cleared the problem.
Jason
2025-06-22 10:24:30
Inexpensive and works great.
Neil Jensen
2025-06-06 18:03:22
Catalog number does not match description it is a jacobs 33 taper to morse #3 not a #3 to #3
Norb Kelly
2025-05-24 13:24:28
The DEWA0233 is a #33 Jacobs taper, not a #3 taper as advertised. If you look around there is a DEWA0203 listed and this is the #3 Jacobs taper.
jeanine aubertin
2025-05-13 09:00:58
Don't assume this arbor is 7/16-20 like I did. The one I received has a thread size of 1/2-20... try to find a drawbar that fits it...
Tanya Hobbs
2025-03-06 20:46:59
Beware this is for a #33 Jacobs Taper not a #3 Jacobs Taper.
Frank F.
2025-01-22 17:19:19
Wrong, Wrong, Wrong - This is NOT a #3 MT to a #3 JT. It is a #3 MT to a #33 JT. Part number DEWA0333 Indicates a #33 JT.
John C
2024-12-30 16:07:11
Seems good
Rick
2024-11-24 21:59:21
Well it is advertised as #3 witch should be jt3 instead it's a jt33 too small
Recommended Products
$17.29
$ 7 .99 $7.99
$39.37
$ 18 .99 $18.99