Your cart is empty.
Your cart is empty.Product Description
Universal GPU Cooler(Check Size Carefully)
It is universal GPU Cooler,can fit for most of the market graphic cards.
Size: 7.36 * 4.72*1.18inch.
Please check the size and make sure it can fit your pc perfectly.
Double Ball Bearing
The double ball bearing has a service life of 65,000 hours
Metal Fan Grill
Protect Fan Blades.
Prevent wires or foreign objects touching the blades,
Causing interruption or obstruction.
Two Power Supply Methods
1. Connect to the motherboard power
2. Connect to the computer power supply with D-type interface
Easy to Install
You can easily install it on your computer with the supplied tools, and one screw can complete the fixation.
Power D-type Interface
Four interfaces, three voltages.
Different voltages with different airflow, speed, and noise.
You can select the appropriate voltage interface to start the fan.
5V interface: (1500RPM) Small airflow, very quiet.
7V interface: (2000RPM) Moderate airflow, relatively quiet.
12V interface: (3000RPM) The fan working at full speed, big airflow.
Eric
2025-08-01 16:23:18
I recently purchased this dual fan graphics card cooler, to enhance cooling for my graphics card in my gaming PC. Here's my experience with the product:**Pros**:- I appreciate that I can select the voltage interface (5V, 7V, or 12V) to adjust airflow speed and noise levels. This feature allows me to customize cooling performance according to my needs.- PCI bracket made installation easy.**Cons**: Unless the PCI bracket is screwed down tightly, it will sag, depending on the orientation of your build.**User Experience**: Installing the fans was relatively straightforward, thanks to the included PCI bracket and screwdriver. The setup process took only a few minutes, and once installed, the fans performed as expected – keeping my graphics card at a comfortable temperature during gaming sessions.**Final Verdict**: Overall, I'm satisfied with this dual 92mm fan graphics card cooler. While there's room for improvement, the fans have provided reliable cooling performance and have helped maintain a healthy temperature during gaming sessions. If you're looking to enhance cooling for your graphics card, I would recommend considering this product, especially if you prioritize airflow and quiet operation.
Allen
2025-07-31 12:27:39
Had a graphics card with a dysfunctional fan. This helped to compensate for cooling. Quite nice that I can position it behind my graphics card to assist in venting heat.The slightly loose wiring that connected to the connector did create some inconsistency in performance until I nudged it in. Thankfully the solution was easy.
David
2025-07-21 11:06:34
For being such a simple product, I can't recommend it more for anyone that has network card thermal problems. I previously had a ten gig dual SFP card have massive thermal issues that would cause my network to slow to 100mbps. After adding the card and plugging it in, with the fans pushing air over the card - it fixed the problem. The few times I've gone back to inspect the system, the card is just a tad warm - not burning hot. So, it gets a thumbs up from me.I was trying to jury rig something like this, but I'm so glad someone still makes these. I have a PfSense box for a router since I don't like leasing a bad one from my ISP, and it allows mine to run cool.
M B
2025-07-19 16:23:48
I had heat issues with my m.2 card. I tried multiple heat sinks with fans that cost $20-$30 with little to no improvement. I moved my graphics card to my 2nd PCIE 4.0 slot. Put this in its place just in front of my 4th Gen m.2 blowing away from it and towards the back of my GPU. It not only brings fresh air into the case but also pulls air over the M.2 heat sink and then blows it onto the back of my GPU. It has cooled my GPU down by 5C and my M.2 4.0 Card went from a whopping 58-62c under load to now 34-38C idle or under load. That’s not a typo and it’s pretty amazing. I couldn’t ask for a much better cooling solution other than the fact that it puts out slightly more noise than my other 3 case fans. Since it's on a gaming machine I really don't notice it anyway.
Carlo Cardenas
2025-07-14 17:29:20
Working right as intended, bought it because my GTX 1650 PNY card fan died and couldn't find replacement parts, it works better than the stock fan to keep the card cool and running smooth
froth45
2025-07-04 14:01:24
Quiet Operation needed 5 volt wiring.
Tana B.
2025-06-10 15:05:20
The 5V connector is whisper-quiet and provides decent airflow. I am using the 7V connector right now which has just the slightest fan noise and appreciable airflow. I am using this in a Windows server running an LSI MegaRAID adapter card, and it's doing the job and then some.
Oliver
2025-05-09 10:08:23
Is ok for the price
Atvaark
2025-04-24 12:01:44
Cooled down a 10gbit card, and an HBA at one point. There certainly are better solutions, but as a quick temporary fix it does the job well. It's not loud as long as you don't run it full throttle.
Aldo Lopez
2025-02-24 18:21:02
Le quedó muy bien, los materiales son muy buenos.
Ebenezer Emmanuel Martinez Hernandez
2025-02-14 14:30:00
Cómo al parecer es una empresa china la que fabrica este producto, no se tienen los controles de calidad suficientes, por lo que, envÃan productos dañados.
Recommended Products