Your cart is empty.
Your cart is empty.Product Description
Durofix RM602-3 3/8" Heavy Duty Digital Torque Adapter
- Static torque measurement
- Standard functions: Torque setting, measurement setting, mode setting
- Operation in both clockwise & counterclockwise directions
- LCD display shows N-m (or kg-cm, in-lbs, ft-lbs.) measurements
- Audible torque confirmation by means of buzzer
LCD Display
Easy to read LCD display with backlit showing N-m (or kg-cm, in-lbs, ft-lbs) measurements.
Buzzer Alert
Audile torque indicates when the correct torque has been achieved.
Technical Details
- Drive: 3/8" Square
- Accuracy *: CW ± 2%; CCW ± 3%
- Measured Torque Range: 5.9 to 59 ft-lbs (8-80 Nm)
- Resolution: 1 kg-cm, 0.1 N-m, 1 in-lb, 0.1 ft-lb
- Auto Shut-Off: After 1 Minute of No Use
JOHN G
2025-08-25 21:59:28
This device permits simplified torque measurements to fasteners without the need to employ harder to apply torque wrenches. The device simply is installed between a ratchet handle and any 3/8 socket. It’s simplicity will make it a frequently used accessory when replacing bolts requiring critical torque as specified in their installation.
Jamie
2025-08-24 18:54:25
This is perfect for doing angle for head bolts and crankcase bolts. As long as you're starting torque is 25 ft lbs or more, then you can use this and it makes it so easy!Batteries going out will happen. Get some higher quality cr2032 batteries. May have to undo one bolt, re torque, then do angle again if this happens.I recommend this over an expensive digital torque wrench and those terrible angle gauge toys. Unfortunately for me, I have a warped head in my case, but this makes things easier when I do again soon.
Badanasinghe n c fernando
2025-08-17 18:59:21
Â
GoesOutside
2025-07-06 14:33:38
Right off the bat, the batteries are toast. Unit wouldn't function. Bought new batteries. After waiting for this thing to power on for a minute i figured out you need to set it down because it's trying to do some calibration. Each time you power it on it does this. Compared the torque alarm setting to two calibrated torque wrenches and it changed wildly +- 30ftlbs each time it was powered on. The only reason i bought it was to use the angle function. Guess what else is wildly inaccurate.... Not to mention it auto clears the measured peak angle in under 10 seconds. So if you are working in a tight area and need to pull it out to check it, then go back to complete the angle, odds are you will be looking at a new reading from what it thinks is zero. They should be paying us for wasting our time with this junk.
John K.
2025-04-26 16:23:08
Quality item. Arrived in good condition.
S. Godby
2025-04-22 11:11:17
Never could set angle meter on original meter purchase. 0l
Michael Frost
2025-03-24 17:44:41
Much easier to use than the dial angle tool for torque to yield bolts. It does regular torque measurement too but I have several good torque wrenches so I haven't used it for that
Miguel Almonte
2025-02-03 18:55:46
This is a very nice and accurate tool. It works exactly as it says.
Recommended Products