Your cart is empty.
Your cart is empty. Pack of two chemical wash bottles made with Eisco Labs exclusive Performance Plastic. Made of low density polyethylene (LDPE) for superior quality, strength. Innovative Flex Ink won't fade, crack or peel.
No label design offers a place to write contents. Wide mouth for easy refilling. Each bottle features a two piece construction, consisting of the bottle and leak proof cap with built in nozzle. Self venting design eliminates leaks & dripping. The low density polyethylene plastic is very responsive, with smooth bounce back that won't get stiff over time. Easy to control squeeze for dispensing.
500ml capacity.
Tim Smith
2025-08-31 21:35:10
Pickup tubes leak air into product stream creating a sputtering mix of air and fluid making a mess on everything around.
Carl
2025-07-20 18:32:50
I have a few of these with various solvents. They pay for themselves quickly in the amount of solvent I dont spill while wetting rags or applying to small areas.
Chris Butler
2025-05-23 16:44:59
They don't work like they are supposed to. I had to remove the inside straw and I have to hold them upside down then squirting out fluid. I use for water. I use the other for popcorn butter.
ND 120
2025-02-24 12:04:43
Use these for isopropanol, acetone, and cutting fluid. The air vent that is supposed to stop siphoning doesn't allow the more viscous cutting fluid to pump out... squeeze and squeeze and only air comes out. I had to cram a toothpick in the vent hole to make it work. Otherwise these bottles are quite nice compared to the generic ones i had before.
Mark Sims
2025-02-19 10:02:50
Absolute rubbish. Leaks.
E. G. Tacsik
2025-02-01 10:52:49
primarily purchased to hold acetone and lacquer thinner for paint spray gun cleanup ... as with most similar wash bottles, the main bottle is made of plastic #4 - flexible low density polyethylene (LDPE) and has a pretty strong odor ... the internal-to-the-bottle straw also appears to be of LDPE ... the lid and integrated spout is of some unknown/unmarked but relatively hard/inflexible plastic ... while there is no "seal" per se. (e.g., an "o" ring), the mating of the bottle and lid is tight - albeit the outlet/hole at the end of the spout has no means of being capped/sealed ... while these particular bottles are generic as use (no specific chemical designation is displayed on the bottle), the painted/silkscreen white area provide a better surface for writing down whatever the bottle is filled with ... no hesitation to recommend
Shawnta Cody
2024-12-11 16:14:00
I thought this was heat resistant. I would have purchased something else if I would have known.
Jeanne Marie
2024-11-24 15:03:15
This bottle squirts air with every squeeze so it splatters with every squeeze. Inefficient and frustrating.
Recommended Products
