Your cart is empty.
Your cart is empty.This black water temperature gauge is engineered to provide accurate readings under harsh conditions can accurately measure the temperature of the coolant, so as to prevent serious internal problems, and help prevent overheating and or cold seizure. This gauge displays the temperature from 130-280 degrees F of the engine and has a rear twist-on ring mount design to make mounting simple.
Barbara Coker
2025-08-17 10:10:03
It works and seems accurate.
Mark W. Mcelhaney
2025-07-18 11:52:25
Arrived on time, easy to install, and worked in my 1987 Fiero GT.
Dale D.
2025-07-07 12:39:13
This reads about 10 deg less than HPTuners when logging. I have not checked it with a temp gun yet. The same brand Volt gauge reads higher than HPTuners and I verified with a volt meter that gauge is actually correct. My only complaint is the needle isn't illuminated so its a little hard to see at night.
Michael Sticht
2025-06-26 14:02:47
Works great
DBO
2025-06-02 16:13:09
Easy to install. Came only with bushings for sending unit but no sending unit. Hopefully will work with the one I have.
josh
2025-03-15 12:49:41
Very nice looking and easy to see. Works with 74 cj5 wiring harness like a glove.
Thomas J Andrews
2025-02-12 11:45:25
Old-style mechanical gauges wouldn't hold up in my old International 424 tractor, but this one has outlasted them all. Accurate, and easier to install than those older ones.
Juls
2025-02-08 12:49:14
When you try to tighten the nut to hold a terminal down which holds the signal wire, the hole threaded section just turns. Reading doesn’t change in the gauge when running but will raise a good bit with the ground terminal removed. All wiring is done correctly. Sensor is faulty, and so is the gauge. I’d recommend just going glowshift at this point, and I despise their pricing.
Recommended Products
$71.43
$ 34 .99 $34.99