Your cart is empty.
Your cart is empty.Product Description
Ms Bert
2025-08-05 15:49:52
Easy to install
Aerofool625
2025-07-30 10:46:21
My Escape did not have a splash shield when I bought it. A very small piece of the original was stuck on a bolt meant to fasten it. Based on that piece, which seemed more of a paper based fiber, I’d say this new cover should last significantly longer if not indefinitely. It is a thick plastic and the mounting holes lined up almost perfectly. It was hard to get the first few bolts in while holding this up. Finally have peace of mind knowing the engine bay finally has protection from road debris and corrosion.
James Julison
2025-07-24 11:23:43
This fit my car perfectly, ir was a little deformed when it arrived but did lay out back into shape. I had my local garage install it but it came loose on the way home, so I had to get oversized fasteners as they had stripped to originals out. Works great now.
F Priestly
2025-07-07 16:28:56
This Engine Splash Shield part is the perfect fit for the 2013 Ford Escape model and is very reasonably priced, about half the cost vs dealer prices, I am very pleased with the quality of this part and the much lower priced for the same quality and fit as the dealer parts. I highly recommend this to anyone looking for a replacement engine splash shield.
MRB
2025-03-30 10:59:44
Just my opinion, the OEM part was poorly constructed and the dealer wanted $150 for a replacement. Plus installation. We were pleased with replacement from Amazon. Fast delivery, good quality and apparently easy to install. (In and out in 45 minutes) I also bought the hardware package to make sure my local mechanic would have everything he needed. If you have the right equipment to DIY, It shouldn’t be that difficult. Check YouTube and save another $45.
J. Frey
2025-02-01 12:56:33
Installed correctly (watched multiple YT videos) and force of wind alone from driving caused the screws to pull right through the plastic across the entire front of the part
Todd Langhill
2025-01-11 17:42:07
Fit my 2016 Escape ideally. I would advice buying the replace screws before replacing them. I live in New England, and almost every bolt is very rusty.
Adam J Walker
2024-12-01 10:41:39
The shield is more rubbery than the plastic and felt product it replaced. I put it in the sun for half an hour to help it unfold from boxing. I used a new hardware set (Rexka 10 Sets T30 Engine Splash Shield… Screws), which proved useful to replace some hardware that was missing. It lined up well except the rear center bolt hole, causing it not to lay flat. Hopefully it doesn’t vibrate and cause noise, but I’m sure I can cut a hole and use a washer to make it fit perfectly. Overall I’m satisfied, it was a simple install.
Recommended Products
$128.64
$ 54 .99 $54.99