Your cart is empty.
Your cart is empty.Protect your carbides and garage floors with the Pro Series Adjustable Snowmobile Dolly System from Extreme Max! The system's clever design slides underneath the snowmobile's skis and hooks into the ski loop, providing a set of drivable wheels to easily maneuver your sled around the garage, yard, and trailer. The oversized wheels easily handle traveling over grass and gravel surfaces without worry of wearing down the snowmobile's ski carbides or scratching the surface underneath the skis. Each dolly features a full width adjustment to allow the perfect fit for nearly any width ski. Pro Series Adjustable Snowmobile Dollies are drivable up to 5 MPH and work with any modern snowmobile up to 650 lbs.
S. Thompson
2025-08-29 17:38:09
The dolly package I received had a part that was warped, so it was essentially unusable. If the part hadn’t, the dolly would’ve been easy to use and helped save my back from picking up snowmobile skis. The seller (BZB Marine) was extremely helpful and understanding, and offered to either issue a refund or wait until a newly manufactured batch came in. Great customer service!
Jared
2025-08-10 10:36:32
First time I used them they bent under the weight and would not hold the ski off the ground. The metal used is very poor quality. Used them for a 2006 Artic Cat M7.
guy
2025-08-08 14:48:09
They bend very easily. The front has a gap to allow them to be width adjustable. However, this gap causes them to be very flexible and bend easily. I will be drilling some holes and bolting a piece of flat steel across the gap to solve the problem. Should b a very easy fix.
burnem79
2025-07-19 16:32:59
I seen these on sale at a price I could not believe (vs other wheels) so I figured I had to give them a shot not having much confidence in them. First, they are easy to put together. The hardware is not the strongest, I stripped one locknut out on the bolt and had to replace them both. Once assembled I found the bends were not consistent from part to part. Alignment on some parts is terrible. The bushing for the wheel is way too long, I measured difference between the wheel and bushing and it was .104". That is a lot, especially when you drive the sled on the wheels I found the wheels are constantly drifting back and forth. Placing a sled on the wheels is simple. When a sled is on the wheels, there is a lot of flex in the wheels while moving, enough it worries me they will collapse and my carbides are going to dig into my pavement. My pictures are of Ski-doo pilot skis on a Yamaha Viper. The wheels fit perfect on these skis. I tired it on a 2015 Polaris Indy with the Polaris skis and these wheels did not want to stay in place. The loops of the Polaris were too big and allowed the wheels to slide back and forth. This caused the back side of the skis to drag. I tried this on a 2008 REV 550 and the issue here was the wheel on the inside would hit the lower a-arm and you could not center the wheel to the spindle bolt and also dragged the back of the ski. Last sled I tried it on was a 2012 Arctic cat and that worked just fine. For the price, I wasn't expecting much, they get the job done for my light duty work, but I would expect these to bend over time and be no good.
James Fausett
2025-07-15 12:35:02
These work but are easily bent. Only useable on a clean flat surface with no snow present.
Steve B.
2025-06-12 15:41:17
Great quality
Jessica Hoff
2025-05-25 15:32:27
Not sure how they expect these to work without making them out of high strength steel. They bent just turning the ski. Very poor product and basically unusable, even on a flat smooth surface.
Daniel B
2025-05-03 10:07:19
I used the roller 3pack for snowmobiles for years. I had bent metal, lost nuts , and wheels that snagged a small rock and ground flat. But this set is way better and rolls over small dirt without plugging up and dragging wheels. Easy on and off ski, I bought a flat roller from Northern Tools for the track to wheel around in the garage.
ã•ãら
2025-04-02 15:08:13
注文１度目ã¯å¾…ã¦ã©æš®ã‚‰ã›ã©å±Šã‹ãšã€‚ã‚ャンセルã—ã€ï¼’度目ã®æ³¨æ–‡ã§åˆ°ç€ã€‚２回目ã®ä½¿ç”¨ã§ã‚»ãƒ³ã‚¿ãƒ¼Tå—部分ãŒã‚†ãŒã¿ã¾ã—ãŸã€‚強度ã«å•é¡Œã‚ã‚Šã¾ã™ã€‚
Gerard ward
2025-03-08 10:04:31
Haven’t used it a lot however I do share the view that the dollies are not strong enough for heavy snowmobiles and will eventually break if not reinforced. Wheels are wobbly and need extra bushings.
Dominic C.
2025-03-01 15:13:53
Pour rentrer ma moto-neige dans mon garage
Steve
2025-02-27 12:23:14
I own 2 of these for my snowmobiles and they're great. I can now maneuver my sleds as easily as a 4 wheeler. Game changer
Fil
2025-02-09 17:05:10
Skidoo tros lourd pour les roulette
Recommended Products
