Your cart is empty.
Your cart is empty.Product Description
Patented designs and enhanced quality sets our brand apart.
The Classic 1-inch EZ Lip Front Splitter offers basic scrape protection and a sportier appearance.
Universal Fit design for EZ Installation. No drilling or screws required!
Hide existing scrapes and prevents new damage from everyday driving hazards such as speed bumps, driveways and parking curbs.
Explore our Features & Benefits:
-
Fast & Easy Installation
- No drilling or screws required
- Works on most cars and trucks
-
Handles All Conditions and Weather
- Protects from costly paint damage
- 3M adhesive with all-weather durability
-
Made in the USA
- Customizable
- Compatible on front, sides or rear
-
Lower your car by up to 1-inch
- Get a lowered look in minutes
- Transforms the look of your car
Our products can be installed on any car including Dodge Chargers, Tesla, Honda, Nissan, and more!
-
Installation: Step 1
Peel protective film from tape starting at one end of the Front Splitter and attach to surface of vehicle.
-
Installation: Step 2
Firmly press and hold the Front Splitter for several seconds against the surface of your vehicle. Make sure there are no air bubbles or gaps.
-
Installation: Step 3
Cut excess off with scissors.
Front Splitter
Compare our Splitters
1 inch | Lowers your car by | 2 inches |
3/5 | Durability | 4/5 |
| | 3M Adhesive | |
Dura-X Foam | | |
InvisEdge | | |
Dual-Edge Protection | ||
Serrated Adhesive |
1 inch | Lowers your car by | 2 inches |
3/5 | Durability | 5/5 |
| | 3M Adhesive | |
Dura-X Foam | | |
InvisEdge | | |
Dual-Edge Protection | | |
Serrated Adhesive | |
- Front Splitter PRO
- Front Splitter MAX
Paul Nelson
2025-08-23 15:09:30
EDIT: Updated review. I purchased the EZ lip in January 2020 and this last weekend, it finally ripped (August 2021). My car is lowered and I try to drive carefully on roads with dips/bumps. There are some roads where there just isn't much you can do. On these roads, I've scraped the lip and for the most part, the lip had held up well. There were a few scuffs on it, but nothing that was easy to see so I wasn't worried about it. However, this weekend I was driving and scraped it (didn't think it was very hard) and it ripped the lip. Moral of the story, it's a good lip... it's cheap and looks good. I'm not out a ton of $$ like I would have been if I purchased a "real" lip for this car. But after this, I'm not sure if I'm going to replace it or not.I've been wanting a lip for the front end of my Fiesta ST but didn't want to spend $$$ on something that was, 1. only for looks, and 2. probably going to meet a few speed bumps eventually.The EZ lip was SUPER easy to install. I left the tape out in the sun on a hot day to get it nice and warm. I cleaned the bottom of my bumper and honestly didn't even do a great job (no alcohol or other adhesive prep). I lined it up before peeling the tape off to get an idea of how I would handle the different curves in the bumper and when I was happy, I started at the passenger side wheel and then, working about a foot at a time, stuck the lip to the bottom of the bumper. I pressed it on in sections, pretty lightly just in case I needed to peel it off and move it. When it was all the way done, I cut the end and firmly pressed the lip onto the bumper. All said and done, took me all of 4 minutes to install, minus the cleaning time.The lip itself is soft. It's made of what feels almost like a foam. I guess I was expecting it to be more rubber-y based on how it looks, but it seems durable enough. It's easy to tear it if you try to rip it, but I don't expect that I'll have any problems on the car.As far as the adhesive, after letting it set for a few hours, I pulled on it... HARD. The bumper moves but the lip is solid. Also, because the lip is made of soft material, I expect that it will actually resist any scrapes with speed bumps pretty easily.For the price, I highly recommend this lip if you're looking for a bit of style. Really adds a lot to the look of the front end for a pretty low price.
Mark Thomas
2025-08-07 13:50:34
I'm putting 5 stars so people can see it first,I have bought easy lip in the past for my GTS Lancer and it looks great made it look lower and everything... But when I went to home depo one day I saw pretty much the exact same thing for more than half the price... GARAGE DOOR BOTTOM RUBBER! yes I'm serious... I was so pissed that I would have bought that for 9 bucks and it's rubber and not this cheap easy to rip stuff and this stuff costs 30 bucks! No way, now I have an integra and I bought the garage door bottom rubber and yes it's a bit more work but you're saving 20 dollars, so in my opinion it's worth it! This is what it looks like the the garage stuff, do you see a difference? Because I don't, and yes I had to make holes in the lip it has but I only needed to make 4 and it's on the bottoms no one would ever notice. But it's up to you guys! Just thought to give my 2 cents about it.EZ Lip is a very nice solution for ground effects for pretty much any car.. It is very simple to install. the double sided tape is fantastic and pretty much never unsticks.. make sure the bottom of your front end is clean, I use rubbing alcohol afterwards to make sure there is no nasty on the plastic and bam just roll it out and stick it on. its that simple. I used this on my 2008 Honda Accord Sedan and it came out just gorgeous.. it have the car a really nice sport look .. its flexible so, if you scrape a curb or parking space it wont hurt it. I attached a photo of the finished product on my car .. you can see the difference with the lower ez lip
Honest Review
2025-07-17 18:52:26
Pretty cool and nice little detail to add to your car for those who are wondering it’s a robber piece
Joe A
2025-06-29 19:45:06
This product is a joke. It's overpriced well marketed Foam. Yes, Foam, not rubber. It has absolutely no durability as they claim. If the product comes into the slightest contact with anything, it begins to show signs of use. You would think that since the product is the lowest point of the car they would have used some special material to make it durable as I thought it was. I have not tried the "Pro" version but I'm not about to drop another $40-$50 to find out.I had this product on for less than 2 weeks on a car that was not lowered, and it does not look good anymore. Worst part is that they won't refund your money, instead they offer 30% off the purchase of a new one. Which in my opinion is insult to injury. Stay away from this version of this product it's a waste of money. Unless of course your willing to drop $35 every few weeks or you have a lifted 4x4 vehicle.Here is the response you'll get when you complaint or ask for a refund:"We're sorry to hear this. Due to the nature of this product, the EZ Lip may get damaged over time. The product's durability is dependent on how well it's installed on the vehicle and how you drive. For these reasons, we do not offer a warranty except for manufacturer defects upon receipt of the product.Based on the images, it appears the EZ Lip has suffered some scrape damage. This is normal type of damage given it's flexible rubber composition.We have recently released the all new EZ Lip PRO model which is made from our strongest Dura-X Foam compound and can absorb far more scrapes before it begins to deteriorate. It also has our Patent-Pending InvisEdge feature for a seamless and professional appearance.As a valued customer, the best we can offer you is a 30% discount on your next order from our website. Just use promo code 30off to receive the discount.Please let us know if there is anything else we can do to assist you."
Rickie
2025-06-22 12:22:38
Great way to add a nice detail to your car - improves the general look of your front end without having to buy permanent/pricy lips. Cleaned the bottom of my bumper with soap and water to remove general grime then with isopropyl alcohol to promote adhesion and it worked great!Tested a small leftover chunk on the bottom of my rear bumper after doing the same cleaning process to see how good it really is and it turned out to be WAY stronger than expected - The Dense foam like lip material actually ripped before the adhesive failed and it took a lot of force to do so (still have the leftover adhesive on the bottom of my bumper - easy to scrape off I just haven’t had time haha)Definitely wouldn’t worry about it coming off on the highway or after rubbing on a parking curb!
Alexander Heim
2025-04-01 09:34:23
Hätte nicht gedacht, dass die Lippe so gut hält. Hab sie an meinem E38 montiert und es sieht richtig gut aus. Schön dezent noch ein Stückchen tiefer. Würde es sofort wieder kaufen!
justin
2025-03-22 16:09:25
Looks great on the car, a little tricky to get on nicely but once they stick they aren't coming off.Nice unique style touch to the car. The white is a rather bright white, but still matches the 14 year old car well enough.
M. Nijenhuis
2025-02-10 16:30:14
Als je de montage voorschiften volgt (schoon oppervlak, lijm eerst verwarmen bij koud weer) heb je een bumperlip die er goed uit ziet, erg goed blijft zitten en bovendien de bumper enigszins beschermt tegen schade.
Rémi Grospeiller
2025-01-12 13:01:52
Bon compromis si vous voulez éviter les lames rigides , bien nettoyer le bas de caisse avant application et extrémité à renforcer avec de la colle à caoutchouc
Recommended Products