Your cart is empty.
Your cart is empty.Once you’ve installed an aftermarket Fuel Filtration System such as our FASS Titanium Series, the use of the factory fuel filter is no longer required and can be removed. Because your Duramax factory fuel filter is located after our filtration system you will still need to replace the factory filter every 5,000-8,000 miles. This filter delete kit will replace your now useless fuel filter with a spin on canister that will allow fuel to flow freely into the engine, saving you even more money. This spin on Fuel Filter Delete Kit is a perfect addition to your FASS Titanium diesel fuel pump and comes with all required hardware for a professional installation.
Karen Grimes
2025-09-05 10:38:07
These work really good good
Kdub
2025-09-03 12:43:12
Super easy, but follow the instructions for the check ball or your rig won’t run for more that a few seconds
Shawn Edwards
2025-07-31 20:52:42
Seems well built like you'd expect from the brand, haven't installed yet but I will leave 5 starts. If something goes wrong I'll just come back and edit
Brittiny Griffin
2025-07-28 15:27:13
I can’t get it to seal properly. I’ve tried to install this 3 different times and it leaks fuel where it screws on the filter housing
Customer LP
2025-07-17 16:45:28
Followed install instructions. Works flawlessly. ('07 GMC Duramax classic) have the FASS fuel filter system. Wish I would have known about that years ago!!!! No turbo lag whatsoever!!!
Scott Bobrosky
2025-05-31 11:11:18
Quality machine work. Fits perfectly.ATTENTION: Make sure to follow the instructions on the FASS Website. You must remove the ball check valve from the filter head or your truck won’t run.
Tyler
2025-04-30 21:15:28
Installed at the same time as my Fass 150 once the wheel shroud is out of the way install was quick. Make sure you read the instructions and don’t forget to pull the check ball out of the filter housing.
Whitney Dittman
2025-04-20 14:59:53
So I installed the delete after my system and installed a pressure gauge as well (about 2 months after installing a lift pump so that hopefully all the nasty diesel is flushed out but... I didn't remove the ball valve... got frustrated with the issue and while trying to diagnose, left the intake tube off while I cranked it. Eventually realized my issue and removed the damn ball valve, primed it, and it started working but I got maf sensor fault error codees and the countdown of death ... SERVICE EMISSIONS SYSTEM 165 MILES to 65 TOP SPEED... So now I cleared the maf errors and it runs ... limpy because its in emissions limp mode. Have to take it to the dealer to get the codes cleared and hopefully restore my system to full power...5 stars for quality1 star for a lack of "DONT BE A DUMMY" label that told me to read the instructions again and remove the ball valve before I end up in this shitty situation.
Roger Vanderlee
2025-03-26 11:33:09
Replaced the factory filter with this when installing the FASS System, no longer have to mess around behind the inner fender.
Abe
2025-01-13 17:46:16
Fast shippingGreat quality
Recommended Products
