Your cart is empty.
Your cart is empty.FastCap FE.SP.15/16-50.WH 15/16 x 50' FastEdge PVC Edgebanding, WhiteFastCap FE.SP.15/16-50.WH 15/16 x 50' FastEdge PVC Edgebanding, White Features: Durable and easy to use, FastEdge is made from high quality PVC High performance pressure sensitive acrylic adhesive increases in strength as it cures, providing a long-lasting, permanent bond 15/16 x 50'*Image shown may vary by color, finish, or material
Kathk
2025-08-16 18:01:37
painted our cabinets in kitchen white, and this tape works great to cover up the shelf edge. completes the look inside (since we didn't paint the insides of the cabinets). it is VERY sticky to work with, even sticks to your skin easily, and takes time to measure, cut and install but once up looks great. just take some goo gone after you are done and wipe down the scissors and the edges of this to finish the look.
Some dude or his wife
2025-08-03 16:36:32
This product works great. It is extremely sticky. The iron on edge banding I have used in the past has been very brittle and tears apart very easily, this does not! I made sure to wipe the surface down to clear any loose dust off and applied it with a roller, then the edge of a wood block. I used an old single side edge band trimmer that I have and then softened the edge with a file. A new razor blade scraped along the edge took care of any excess glue, there was no need to clean the razor blade over and over as others have indicated. I have been a cabinet maker for over 15 years and this product performed just how I would hope. I will definitely buy this product again and again as needed. It is expensive and somewhat time consuming to put on but this will not break and peel off as other edge banding will.
Richard K. Holland
2025-04-05 17:17:45
I like this so much better than iron on tape.Much easier and great glue.
stillafewleft
2025-02-08 14:36:24
Worked very well to finish off melamine board edges, but I was surprised - given that it is called "Peel and Stick" - that it required contact cement for particle board-type material. However, applied 45' after 2 thin coats of Weldwood nonflammable (nonstinky and pleasant to use with a disposable 2" brush) contact cement applied about 45' apart it did just fine. Trimmed up nicely with the Quad trimmer.
Maryanne Byrnes
2025-01-22 13:24:31
Wonderful Edging for tables and shelves. This roll of laminate is self-adhesive with a heavy duty adhesion. It is lightweight and very easy to trim to the proper size. It goes on easily and it can be repositioned before the adhesive completely sets. I purchased it for a set of outdoor chairs that had peeling strips on the arms of the chairs. After thoroughly cleaning, repairing the finish in some spots and painting worn areas, I installed this product. It completely replaced the old strips. The color is an almost perfect white. No one could tell that the strips were not original. They helped to make these chairs to look almost 'brand new.' A few of my kids did not recognize the chairs after they were finished. Highly recommend. Great Buy!
Steve
2025-01-11 16:28:54
Worked great!! Made a few cabinets with some Melamine, one pc I wasn't very careful when applying and had to peel it back somewhat. In doing so it pulled some of the particle board back leaving a few small pcs on the tape. So now I have a spot with some lumps and imperfections. This stuff does stick and well!! Very easy to trim because it's like a vinyl. I used my block plane, LIGHTLY, on about a 15 degree pitch and it cleaned up great. Would recommend to anyone ...... GET RID OF THE IRON!!!!
miltjp60
2024-12-30 11:18:02
fast cap makes good products always !
Ovard-Halle
2024-11-30 18:17:39
Give me iron-on edge banding any day! This product is way more difficult to work with than iron-on edge banding, and much more messy! The biggest problem is that it stays sticky even after it is stuck on so you can't trim the edges without getting your blade all gummed up with a messy adhesive. Iron-on products sticks better and stronger than this stuff does, and it doesn't gum up your trimming blade or scissors.No matter how you use this stuff, it is a mess, and you can't get it off your hands when you're done without using solvents on your bare skin.Take a piece of advice from a professional craftsman who owns a custom furniture business: and buy iron-on edge banding instead!
Recommended Products
