Your cart is empty.
Your cart is empty.FelPro gaskets offer 100% vehicle sealing with applicationspecific materials to give you sealing solutions with the performance and durability professionals trust
StandingElk
2025-08-29 12:08:10
They fit perfectly, gaskets are nice and thick to prevent leakage, the prices on Amazon were cheaper than the parts house. Good quality item from Felpro that look great.
Steve
2025-08-19 10:34:12
I put these on a 2013 Silverado 2500HD. The exhaust manifolds were torqued to factory specs. The engine was ran for about 10 minutes to achieve temp. Then the engine was turned off and allowed to cool. The manifolds were then retorqued again to factory specs. No issues to report after 4K miles. I have years of confidence in Fel-Pro gaskets.
Don clawson
2025-08-10 14:45:44
Loved the ease of installing and better quality of gasket thickness
Syrina
2025-07-05 14:07:25
Oem quality and fitment
Angel S.
2025-07-01 13:19:50
Used these instead ofMLS gaskets to fill any impurities on the head. Have been on for almost 2 years and have been good so far. For installation install header bolts on farthest sides, hand tighten them then hook gasket it then secure it with another bolt to ensure it doesn’t fall out.
Chaison's Garage
2025-06-26 12:37:07
Good quality gaskets to replace my brittle failed OEM set. Went back to check tightness after a few miles and there had been no leaks at all.
Erik Antonson
2025-06-23 17:08:55
Like the thickness of the gasket. Fit perfectly on 2011 2500HD and sealed properly.
Hannah G.
2025-05-31 09:35:41
Good quality fit and fit as it should. The hooks on the end of the gasket make life much easier on the install. I think factory torque spec was 18 ft lb. Be careful removing the manifold bolts, mine the infamous yellow GM thread lock. 2 of mine were already broken, one required me to weld a nut on to back it out so take your time and put some heat to them if don’t come easy.
Ohno
2025-05-26 13:04:04
Installed on my Chevy 6 l. No leaks.
ronbchamp
2025-05-19 11:03:09
They did the job with no issues.Update: March 23 2019 These were installed on my contractor work van and the van still runs excellent with no exhaust leaks. Fel-Pro gaskets are worth every penny and should be used for any and all types of engine repairs.
Arctic cat
2025-03-30 16:38:28
the fit and finish is Fantastic.
FaceDeAce
2025-03-12 18:31:14
Great quality gaskets. The truck no longer has tick fits. Sealed up and quiet now.
Bradley Dougherty
2024-12-14 14:42:19
Fit perfectly, vortec tick is gone on my 6.0LAfter replacing these. Studs and doughnut gaskets also replaced at same time as it was apart and 4 studs snapped with the heat cycles
Recommended Products
