Shopping Cart

Your cart is empty.

Your cart is empty.

FLEOR Alnico 5 P Bass Pickups Humbucker Pickup for 4 String P Bass Replacement

4.7 (12) Write Review
Free shipping on orders over $29.99

$23.99

$ 10 .99 $10.99

In Stock

1.Size:Bridge Pickup


About this item

  • P Bass pickup for 4 string P Bass guitar part or similar bass guitar pickup replacement.
  • Alnico 5 magnets, Pole Pieces:4 Flat Pole Piece.Fiber plate bobbin.
  • Pole Spacing: 28.5mm, Resistance: 9-10K.
  • Wax potted to eliminate any unwanted feedback and noise.
  • The bass pickups come with screws and springs, easy to install.


Wax potted to eliminate any unwanted feedback and noise.


sixteen again
2025-09-05 12:13:34
I ordered the alnico 5 jazz pickups. Great packaging. They took a while, so I think they came from China. I was surprised they had cloth push back lead wire. They were easy to install. The screws are a bit soft so make sure your screwdriver is well seated. Sohnd wise, they sound like solid Alnico 5 jazz pickups. They definitely sound better that the low output ceramic pickups that were in my 2002 mim jazz bass. For the price I'd say try them. Are they as good as boutique pickups. Maybe not but I bet anyone in the audience would be had pressed to tell I spent under $40 for a set of pickups compared to $140.
Mayhem
2025-08-25 16:42:42
I almost hate to say this, as China and Amazon seem to be taking over everything but these pickups are great. I own a Squire Affinity P Bass for which these pups are a HUGE upgrade. These sound so much richer, fuller and musical than the stock pups it's hard to believe the performance vs price ratio. I probably paid on the high end for these as they sometimes go on sale for about 2 dollars less but I didn't want to wait and they are well worth it.Installation was a cinch as the P bass has its 2 pups wired in series, these FLEOR pups came already wired in series leaving only the black and white wires to be soldered to the pots exactly how the old pups were wired. Pick guard is tight on these but did't require any modification though you could open the pups hole up just a little bit, and I mean just a little, you don't want to butcher your pick guard. If I was going to open it up I'd use a fine file and just gently take off a few thousands off each side of the hole. Still, I didn't need to but pickups are tight so it's up to you, didn't bother me. If you want to raise these pups after install you might have to pull them up with your fingers after loosening the screws as they're tight enough they won't float back up on their own without a little tug.Again though, people say for the price, but to be honest these are good enough I couldn't really see justifying paying for Duncan's unless you're a top professional. Even then, these have a character of their own and the frequency response is very nice, once again, giant improvement over Squire stock. If you have a bass and the pups aren't doing it for you, try these, you might be pleasantly surprised.
GJW
2025-08-06 12:53:02
I bought this to upgrade a Squier P Bass. The install was easy and the pickup sounded great, a huge improvement over Squier's stock pickup. The problem arose when I tried to replace the pickguard; the pickup covers were too large to fit through the cutouts. I tried three different pickguards, including one genuine Fender from my American Professional P Bass, with no luck. I then tried replacing the pickup covers with a set of Fender covers. I was able to get them on the pickups and put on the pickguard, but the magnet holes didn't align, so I put the original covers back on. A little filing/sanding on the pickguard cutouts was necessary to get everything situated.If you're willing to do a little minor surgery on your pickguard cutouts, this is an excellent low-cost alternative to a genuine Fender pickup. Except for the odd-sized covers, this would be a 5-star pickup.
Mittentastic
2025-06-27 18:34:08
This might be the best upgrade you can make to an old beater P-Bass. I was looking at my friend's MIM Standard recently, and the electronics had become intermittent. I took a look at the pickup (cheap ceramic, really, like most MIM Standard stuff) and found that we needed a new one, so I ordered this.Honestly, I was impressed in finding that this pickup is as fine as any aftermarket pickup I have bought. The build quality is very good, and mine came with mounting screws and height foam/spring, where you put the spring inside the foam to give the pickup a very secure mounting setup. This is a vintage output, very standard issue P Bass pickup w/ Alnico magnets. There are other more expensive pickups that you might prefer, but you might also find that you prefer this one over ones that are more expensive if you prefer a vintage sound. It won't be an upgrade if you already have a vintage output Alnico pickup, but if you wish your MIM Standard or Squier Affinity sounded more like a real P Bass, this will definitely get you closer. Mine measured around 8.6K.The only thing I might suggest is that, as with all bass pickups, please be very gentle with the flimsy mounting screws and use the correct sized screwdriver. Put a little soap on the threads before you screw them in, and don't strip the heads. I actually ended up using Fender pickup screws, which I already had, and you'll be glad to know that these pickups can handle not only the stock metric screws but also the slightly fatter USA spec Fender mounting screws.
Gary H
2025-06-11 15:50:49
I replaced the pickups on an older Squire jazz bass, and they were an exact fit, easy to install and my customer is pleased with the look and the sound quality of these pickups. It's a good deal for the price!
Customer
2025-05-16 12:25:04
These are ridiculously inexpensive and sound great. They were an easy install in my Squier Affinity Jazz Bass and a definite upgrade.
Scott Burke
2025-03-22 15:13:00
The tone is decent and minimal noise, only a small humm. Not the best bass sounds ever, but better than my original Glen Burton cheap pickups. These don't come with instructions and they don't come with any foam for under the pick ups. The screws strip out very easily and make lots of metal shavings that stick to the pick ups. I had to reuse the old screws. Each pickup is labeled "bridge" or "neck" but they don't tell you which side is up or if it matters if the pickup is rotated 180⁰ or not. It doesn't come with any foam to go underneath them and my original guitar had a different pickup depth. I had to cut my own foam for this out of some weather stripping.
Customer
2025-03-09 15:46:20
Item is exactly as advertised..I would buy it again!
EmmaBroken
2025-03-02 10:05:48
La verdad no pensé que sonaran tan bien, calidad precio superó lo esperado!
時々レビューするよ
2025-01-11 11:25:38
Ariaの荒井貿易が別途売ってるクズブランド、LEGENDのベースの改造に取り組んでる中で、ピックアップ交換の必要性が出たのですが、安い木材に高いピックアップをつけるのはもったいないので、こちらを購入。二つセットで５千円は激安。しかし、音質は予想外に良かったです。非常に深みがある、本物の楽器の音です。ただし、価格も価格なので完璧とはいかず。どうやっても、２弦の出力が弱めです。（ばらつきの問題なので、多分個体によってこれは違うと思います）「安く改造する」コンセプトなので、まあ、これはこんなもの、ということで使ってますが、もしこれをライブなどで実用にしようと思ったら、イコライザーなどで調整すると良いでしょう。とはいえ、コスパが良いので星４つです。
Anonymous user
2024-12-10 13:17:59
The connecting wires are trash quality but for the price these work a treat and sound fine, good value.
Denis Jugan
2024-11-28 13:17:33
tres bien venus tres vite