Your cart is empty.
Your cart is empty.Product Description
Kage87z
2025-07-15 15:21:17
As I was installing accessories from my BBC to SBC swap. I noticed my SBC did not have power steering. So, I attempted to use the bracket from the big block, but the pulleys on the pump would not align with the water pump pulley.I tried various solutions, such as using washers and longer bolts, but I either couldn't get it aligned or couldn't get it perpendicular.This kit made that a snap.Pulled off the pully, accessed the bolts, quick and easy... and easy to adjust.If pully alignment alignment is an issue, especially for an engine swap, then this can help you out and reduce/eliminate the frustration aspect.
johnston
2025-07-04 17:04:10
Great looking product, works great for my application because my engine has cylinder heads that are not drilled for brackets
Dan
2025-05-20 12:13:14
Should have two adjustment arms. One front and one back. The single lets the pump twist in bracket when belt is tightened
Mike
2025-04-29 17:21:37
I was concerned at first the aluminum might flex but it didn’t. Fit perfect no mod needed.
buddy
2025-04-24 13:29:47
This bracket fit well. It did need 2 small shims to align with crank pulley. Metal quality isn't very high. If this was made out of some stronger steel or aluminum it would be great
Chuck Bedford
2025-04-04 15:26:32
Worked perfectly on my car.
Josh D.
2025-03-28 18:10:48
The bolts were not the correct thread for my Sbc, aside from that, the hole in my water pump is not threaded, therefore I can’t bolt this bracket down. Completely useless.
Customer
2025-03-21 15:42:45
Had to figer out How it fits... not so bad
Rubén DomÃnguez
2025-03-14 10:00:13
Tuve que realizar una pequeña modificación, pero nada mayor
Ron
2025-03-12 16:56:48
Very light and fits perfect on my sbc and lines up with the pump perfectly.
Ron
2025-03-04 13:12:27
had to change a mounting point on the pump and then it bolted right up.
Customer
2024-12-25 13:50:35
Mine was a custom install, but these made it easier and about the same cost as buying aluminum stock and making my own.
Wayne Crabtree
2024-12-21 10:40:11
I used this to install power steering on a 1963 Chev c10 and it worked great
Recommended Products