Your cart is empty.
Your cart is empty.Product Description
PQY Front Brake Line Lock Kit Heavy Duty Type Roll Control Hill Holder Kit
- For drag racing to lock the front tires of the car,Works with 12 -24 volt electric systems.It can handle pressure spikes up to 1000 psi.
- Keep the brake pressure on the front or rear brake to keep the vehicle on the start line on the hill or start line.
- This high quality solenoid valve controls both the front brake and the rear brake. Make the brakes more convenient.The line lock kit contains a heavy duty push button switch, switch bracket, coiled wire, rebuildable line-lock valve, fuse holder, and indicator light.
SIZE DETAIL
NOTE
Moparich
2025-08-13 10:24:00
Installation was easy you do need to get your own adapters for the 1/8†npt ports. Build quality is solid doesn’t look cheap.I am installing to goof around. Function will have to wait a few months but I will update
Jonathan leo
2025-06-21 13:03:44
Works as it should make sure you read instructions for which ones are inlet and outletsVery simple install just took some figuring out brake line fitting sizes
robert maxey
2025-06-20 10:05:56
Does not work! Holds 5 psi on my brake line. Wasted over 3 hours troubleshooting and trying to get it to work. I cut my losses and purchased an American made Hurst brake locker and it holds 1200 psi just fine.Cheap non-working Chinese junk has cost me so much time and money this spring, buying the low cost imported product is not always a good value. In this case trying to save a hundred bucks cost my over 300 and a 2 week delay in my project. Buy American and it will work first time!
jose
2025-06-16 18:30:09
It good
Ryan
2025-06-14 09:26:28
I recently purchased one of these units which turned out to be defective (leaked from the bottom solenoid nut). The seller responded to my negative feedback same day, resolving my issue. Thanks again!
Blaize
2025-06-01 17:32:30
If you don’t do it like this. It’ll leak no matter what. Cost me about 15 dollars total to get the fittings and line. It would be well worth the money if the right fittings came included but I would not recommend this to someone who has never done break lines before, it would be awesome if the owner of the listing got back with me for suggestions. This thing is awesome if you got the know how.
Customer
2025-05-03 14:15:29
Makes my car act like a hot rod
Rick
2024-12-13 13:57:15
I haven't gotten to install yet, but if it works as well as it looks... It's a winner!Priced right, all inclusive, and simple easy to follow directions! (Needs more pictures!)Overall very happy!
Matt
2024-12-11 11:08:00
Just installed, installation went fine. Noticed a few people are talking about the inlet port hole being misaligned. Just want to clarify, that misalignment is completely irrelevant. The ports on the housing are NOT flare fittings, you cant thread your brake line directly into the part. You have to thread in the appropriate adapter which is a tapered NPT thread first. The adapter, being sealed by the thread not the flare means the hole in the inlet housing doesnt matter at all if its not aligned. Hence why they supply Teflon tape with the kit. Hope this helps!PS fun fact: you can also see the misaligned hole in the instructions image.
Recommended Products
$32.95
$ 17 .99 $17.99
$39.99
$ 17 .99 $17.99