Your cart is empty.
Your cart is empty.Product Description
Replace Number:
698-446
698446
LK052
44300TA0A61
44300TA0A62
44600TA0A00
45255TA0A00
51215TA0020
Fitment:
✔ Fit for Honda
Accord 2008-2012
✔Fit for Acura
TSX 2009-2014
Notes: Please check your model, year to make sure the steering knuckle is compatible with your car before you pay
Position:Front Right Passenger Side
William S.
2025-08-28 11:23:08
Perfect fit for my 2010 accord. So far so good on the quality. Drove about 4k miles since change
Mike W.
2025-08-19 15:48:35
I would buy this again. It fit up perfectly. PSA: it comes with the lower ball joint, but not the upper. You will more than likely destroy the upper joint during removal. Just sayin. I bought one for $15 at the auto parts store. I also had to press the ball joints out and back in, so keep that in mind and rent the tool if you don’t own one. Good luck!
Shane Carroll
2025-07-23 12:09:10
The castle nut is trash and doesn’t line up at all. It loosed up and caused me to swerve all over the road. Also I went for an alignment and it is not shaped the same way as the last set so the car won’t align. Stay away!
Chasuan kasu
2025-06-16 15:34:01
It arrived fast and fit perfectly on my Honda
Martha M. Maher
2025-04-15 14:19:14
Nice fit and finish. This saves a lot of time in comparison to having the bearing pressed in and getting the old wheel bearing out. My only small complaint is that I had to reuse my old axle & ball joint nuts as the ones supplied were not the same.
Sandra Nascimento
2025-04-14 13:31:56
Good product , but axle screw would not fit axle had to use the old one to mount onto axle .
William S.
2025-02-09 20:46:26
Perfect fit for my 2010 accord. So far so good on the quality. Drove about 4k miles since change
Mike W.
2025-01-25 14:04:32
I would buy this again. It fit up perfectly. PSA: it comes with the lower ball joint, but not the upper. You will more than likely destroy the upper joint during removal. Just sayin. I bought one for $15 at the auto parts store. I also had to press the ball joints out and back in, so keep that in mind and rent the tool if you don’t own one. Good luck!
Shane Carroll
2025-01-24 11:00:13
The castle nut is trash and doesn’t line up at all. It loosed up and caused me to swerve all over the road. Also I went for an alignment and it is not shaped the same way as the last set so the car won’t align. Stay away!
Chasuan kasu
2024-12-22 16:10:51
It arrived fast and fit perfectly on my Honda
Martha M. Maher
2024-12-17 14:19:47
Nice fit and finish. This saves a lot of time in comparison to having the bearing pressed in and getting the old wheel bearing out. My only small complaint is that I had to reuse my old axle & ball joint nuts as the ones supplied were not the same.
Sandra Nascimento
2024-11-28 12:27:51
Good product , but axle screw would not fit axle had to use the old one to mount onto axle .
Recommended Products
$11.99
$ 5 .99 $5.99