Your cart is empty.
Your cart is empty. This is the ideal potting bench for all of your gardening needs. This spacious convenient table allows you to pot, prune, root, transplant and weed your plants. It can also be used as a workbench to organize all your gardening tools in one place for easy access and tidy storage when finished. The ideal design helps save your back from unnecessary strain caused by long time stooping down for ground planting.
This unit is sturdy and weather resistant. For daily care: Water cleaning works fine for the galvanized tabletop. Mild cleanser and wet mopping are recommended for the fir body. This potting bench is an eye catching piece that requires only simple daily care for many seasons of use.
Durable Construction. Workstation is made of 100% solid fir wood board, galvanized metal tabletop, Corrosion-resistant plastic adjustable feet covers, with a Lockable metal latch (lock not included).
Note: Please allow for slight variance due to manual measurement. Do not have this table exposed to corrosive materials.
DT
2025-08-17 15:24:59
This was surprisingly easy to assemble and exactly as expected. Slightly cheap materials but it’s what I expected for the cost. I hope it holds up over time. When it arrived I opened it inside my home where I had planned to assemble it due to the cold weather outside but it had a very strong chemical smell like paint or something toxic so I moved all the pieces outside to air out then brought them back inside after a day or two to assemble it. Build outside or let air out before building if you are sensitive to strong smells.
shirlee
2025-07-04 13:36:48
This is serving me well. I have it on my covered patio. It holds everything I intended for it. Wasn't too bad putting together. Pay very close attention to the instructions. The wood isn't the best and I intend to varnish it next spring in hopes of preserving it.
Graeme J. W. Smith
2025-03-23 15:33:34
True "flat pack" furniture. With line drawing instructions for assembly. Instructions miss an important issue about the fact the large open frames that LOOK the same - are actually "handed" and you need to make sure to use the correct ones at the outset. If you are used to assembling things and look for the holes for the dowels - you will figure it out - but it could do with highlighting in the instructions more than it is. If you are going to use a power screwdriver - set the torque low to prevent over driving.As long as you set up carefully on the 6 adjustable feet - should do OK with a big bag of dirt and pots!Design is good and as long as you can put this somewhere well ventilated - the pine (?) should hold up. Strong smell is either the actual pine, the gray stain or some preservative. Time will tell.
The Tin Man
2025-03-19 16:08:28
This was purchased to replace a garden bench that lasted 10 or 12 years outdoors in the garden. That bench only "wore out" because the (very thin) plywood bottom of an internal storage area was weakened by years of getting wet and then overloaded one day in a burst of confidence, enthusiasm, and carelessness. It seemed easier to buy a new bench than do the disassembly necessary to fix it. Hence this purchase.The new unit is a triumph of design - some student no doubt got great marks for it - but while it uses a minimum of materials to great effect - it's a house of cards where every piece is dependent on something else for support. Summon an octopus from the depths to help with assembly! Compounding the problem is the poor grade of wood used, and the fact that the wood is color-stained but not sealed or waterproofed. I used a LOT of sealer to cover the wood before assembling it and it soaked it up. I still have no confidence that it will last more than two or three years under our difficult weather. The wood is going to split and warp. I also did quite a bit of reinforcement to get decent rigidity that wasn't dependent the design's clever placement of a couple half-inch long screws. I would like to mention that I am not usually obsessive like this - it was forced on me. In summary:Spend a little more money on something more solid.
Ashley E Urbay
2025-03-14 11:00:59
Easy to assemble. Has held up great with regular use and FL humidity.
YYFra
2025-02-04 10:58:12
Assembly instructions ok, but don’t recommend tools . Middle top shelf brace must be flipped the right way to match height of top right side shelf brace … Allow three hours to build . Metal top had a couple of minor dings as packed .
Patti G.
2024-12-18 11:50:54
The product came with a cracked shelf and the metal top was smeared with something black on it. Tried to clean it and wouldn't come off. One shelf has unlevel because of the way they put on the shelf bracket. I unscrewed the bracket so I could move it up to make the shelf level, but it was also glued on. I'll have to add a piece of wood to the bracket to make the shelf level.I would have returned it but was too much of a hassle to repackage and take somewhere for return. It's on my covered porch, so it will be interesting to see how weatherproof it is. I might put a sealer on it to protect it.It wasn't too difficult to put together. I don't have a drill so had to use a screwdriver. Would have helped to have a drill. Definitely takes two people to put it together.
spurs21
2024-12-15 15:02:25
This is a nice bench. It's easy to assemble and looks great. The wood is very soft so probably won't last long outside. I added two coats of sealer but still worry it won't hold up outdoors very long.
Recommended Products
