Your cart is empty.
Your cart is empty.Kendrick Henry
2025-08-23 17:04:39
Perfect fit and took care of my leaks
TS
2025-08-14 15:42:06
Salt water boat. One old seal was so stuck almost broke the spanner wrench before it began to turn. Was a cold day - Took much force to start the new seals on the shaft. Make sure steering shaft (seals mount on) is clean then wipe some steering fluid on it for lubrication also lube seals before installing. Might be easier if you warm the seals before installing.
Dana Alexander
2025-07-30 16:46:55
I didn’t know this came with the compression fittings not tight. After trying to bleed this several times I realized the fittings were loose and allowing air into the tubes. Tightened them and works great!
Jeepin4eva
2025-06-18 13:51:23
not manufactured to oem spec on the threads and it almost ruined the steering cyl One fit just fine. One side went half way in and got stuck very difficult to remove Bought oem seals and they threaded in perfectly
Carl
2025-06-06 15:38:50
Ok for the price I paid but sure was a cheap tool they sent to loose and tighten the seal holder.
George Tammaro
2025-03-28 11:08:47
They work perfect. The wrench is a little Cheap
Jack M
2025-01-11 14:57:17
After watching a YouTube video on how to make this repair I decided to go for it. I also ordered a bleed hose kit for about $80. Took me about 2 hours to complete. It would have taken more time to take it to a mechanic and probably saved me $500 or so. The most time consuming part was just turning the steering wheel back and forth until there was no air. That took better part of an hour. But much easier than I anticipated.
julio powell
2025-01-07 18:38:58
It fit perfect on my seastar system.
Recommended Products