Your cart is empty.
Your cart is empty.3 X 1-3/4 X 2-3/8" Cast Iron V Block Set (3402-1001) ~ Made of high quality casting, properly seasoned against distortion. ~ Machined square and parallel to meet standard specifications. ~ Supplied in a matched pair. ~ A is 3". ~ B is 1-3/4". ~ C is 2-3/8". ~ D is 1-5/16".
Joseph C. Otoski
2025-09-04 16:10:29
I ordered two sets of these V-blocks ( 4 blocks). They are as described. Cast iron and machined flat and smooth on the V top, both sides and bottom. All machine work is very nice. They are painted silver on un-machined rough area. The 2 holes machined in center web are 5/8" diameter. Just wipe off excess shipping oil and they are ready to use.
neal
2025-07-18 10:55:01
Price was good for these. Used for testing the eccentric shaft runout for my Mazda rotary engine rebuild. Perfect size for that purpose.
M. Pittelko
2025-07-13 10:12:05
The V, top and bottom surfaces are ground. The ends are machined, and a little rough. The two faces are machined, and a little rough. In my pair, the V's match well, the top and bottom surfaces match between the two blocks within my ability to measure (less than .001"). The paint is rough, the un-machined surfaces are a little rougher than I would have expected, but not a real issue.They're not the best blocks ever, but they're more than I expected for the cost.
Donald R
2025-07-10 21:22:05
Seem to be well made.
George
2025-07-09 12:03:43
decent set of V blocks.
CraigB
2025-06-28 17:08:03
Well made and accurate V block. I use two of these in my Bridgeport mill, (Kurt vise) to hold production pieces. We manufacture aluminum billet housings that need to be milled on one end. We use these V-Blocks to hold the piece in our vise. They work well and hold the piece accurately.
Jeff Eck
2025-06-25 14:10:10
I've purchased 5 sets, I should have enough for any set up I need to make. Watch price, it fluctuates and you can easily spend more than you have to. I paid $13ish, when I went to reorder more they were $20, so I waited....
Old Grey Beard
2025-06-20 18:30:44
OK for what you pay I guess. Casting quality is poor with minor defects on ground surfaces that were repaired by mfg.and one repair I could feel with my fingernail. Biggest complaint is only the top and bottom surfaces are ground others are rough milled therefore can't be used accurately in other positions such as clamping round stock on your mill vertically.
Customer
2025-05-10 10:49:54
Excellent product for the price paid and fast shipping to boot.
MikaS
2025-04-29 10:29:27
Size Name: 2 x 1-3/8 x 7/8 " Size, 1-5/8 " V WidthThat V Width is wrong. It's not 1-5/8" but exactly 1". Appears as solid product but some - not all - edges are quite sharp so some deburring is needed in most cases.
Jacques
2025-04-24 17:09:10
Je m’en sert régulièrement très fiable
Kboy
2025-02-06 15:03:00
everything is good.
Customer
2024-12-30 10:55:14
J'ai commander 4 blocs et j'en ai reçu seulement 2.La qualité semble bien mais j'ai du passé du temps avec le service a la clientèle pour géré ça
Recommended Products
$29.23
$ 12 .99 $12.99