Your cart is empty.
Your cart is empty.HHIP 3/8" MT3 Morse Taper End Mill Holder ~ Drawbar end thread is 3/8"-16. ~ Hole diameter is 3/8". ~ For single end mills. ~ Shank and bore are hardened & ground.
bald cyclist
2025-03-26 13:55:08
I'm very happy with this purchase. I used it with a 1/2 inch end mill on a 10 inch Atlas lathe, and making small cuts was able to mill quite well.
David L. Parnell
2024-12-27 17:37:39
I liked it...works for me (amateur machinist with a low budget)
Recommended Products
$92.40
$ 35 .99 $35.99