Your cart is empty.
Your cart is empty.1/2" MT3 Morse Taper End Mill Holder ~ Drawbar end thread is 3/8"-16. ~ Hole diameter is 1/2". ~ For single end mills. ~ Shank and bore are hardened & ground.
John Crea
2025-06-30 18:47:00
First impressions were great, looks like a well made tool. However, on putting a 1/2in dowel pin in the tool, it only went in a little ways before it got too tight to go any farther. Needing to be able to seat a dowel pin into this tool, I needed it to go in at least a couple inches, which it would not.Luckily, it apparently was a burr in the bore, and a pass with a 1/2in reamer cleaned up things nicely and make it a functional toolSo, be sure and check that your tool actually goes into the holder as desired. If I had not had a reamer to touch up the bore, this would have been a return and I would likely have given it only 1 star.John
TRUCKER2800
2024-12-20 16:59:56
it is well made and a nice looking unit works well
Recommended Products
