Your cart is empty.
Your cart is empty.HHIP expanding chuck arbor in machine to be used. Tighten expanding screw so that arbor expands 005 inch machine arbor to Length and size required. Loosen expanding screw. Position part on arbor and tighten expanding screw. Product specifications: size: 1"; Length: 4".
squachin69
2025-08-16 09:24:02
Got this for turning duck call barrels. Works as intended, however there are sharp edges. I was able to file down the sharp edges then run some sandpaper to finish smoothing. Not a huge problem with wood barrels, but when turning transparent acrylic you can see the scratches it leaves.
HillbillyMo
2025-07-04 12:02:34
Seems good quality, haven't had a chance to use yet. Shipping time was descent.
Lance Barney
2025-06-13 18:58:26
These are to short to use to hold anything of length on a wood lathe.
Shirley Hamilton
2025-06-10 18:04:12
This is no good should have known better from the review the bolt fits nether standard or metric hex wrenches and even if it did there is next to no hex depth in the bolt so would strip if you tried to tighten .
Ron Weber
2025-04-20 17:13:15
You cant even sufficiently tighten the expanding screw with an allen wrench without it rounding the corners off
Jordan Pagano
2025-03-26 13:38:38
The hex key in the screw was a very poor fit and pretty much unusable. Thread was full of swarth and not well cut.
Fred Wienbarg
2025-02-10 17:23:25
Not long enough to be worthwhile. No wrench supplied to expand mandrel. Don’t waste your money!
Ken Buswell
2025-02-04 18:28:20
The expanding arbor will not expand. Do not buy.I sent it back for a replacement. Same thing with the replacement.
Recommended Products
$87.16
$ 41 .99 $41.99