Your cart is empty.
Your cart is empty. This drive is a DC three-phase brushless Hall less control board. The motor can work normally even without Hall.
How it Work:
The standard speed control of the potentiometer does not require an external control signal.
It increases clockwise and decreases counterclockwise.
Also applicable to external PLC 0-5 analog quantity control Unplug the potentiometer cable, external 0-5 analog quantity control signal and ground line,
Respectively connected with the brushless driver board input signal end, as long as the two lines are OK
Product Parameters:
Working voltage: 6.5-24V
Drive current: Rated 15A (if add fan for Cold 30A)
Maximum Speed: 224000 RPM (2-pole motor), 74000 RPM (6-pole motor), 40000 RPM (12-pole motor), 35000RPM (14-pole motor).
Features:
The ESC is specially designed for the design of all kinds of industrial power tools such as air pump, water pump, oil pump and fan which use DC three-phase brushless motor.
The default medium angle and longtime high current work, we suggest add fan cold as overheat protection.
The external heat dissipation condition of the ESC is poor, and the power is automatically reduced when the temperature exceeds 100 degrees. The temperature drops to 100 degrees and returns to normal.
GMac
2025-09-04 14:08:37
The ESC arrived early and in mint condition. It’s a simple basic looking ESC with a potentiometer wired to it. It’s a power-on system with speed control for your brushless motor governed by the potentiometer. With the knob (potentiometer) turned all the way counterclockwise, you have no movement with your brushless motor. You move the knob clockwise and the motor moves from its stopped position to an increased speed. I like the fact you have complete control of the speed with just a little knob. Plus, if you have your brushless motor running at 50% power and then turn it off, the speed is set, you turn power back on and your motor starts at 50% power. Perfect for our usage. It runs a little hot around 15 amps, but we have no issue with it. As it stands, this little ESC is perfect for our designs and I recommend this item to my family, friends and all who read this review. Happy shopping!!
Terry C
2025-09-02 15:00:27
First product to have a separate " out of the box" direct speed pot. Took it apart and found good construction And it has low heat disapation. One pleasant surprise: They didn't laser ablaze the part numbers!! I was able to get input pin numbers for engineering external control. A hardy "THANK YOU!!".I Ordered 50 more units for a big project .5STARS!
eric black
2025-08-24 10:49:08
if you waterproof the board and set the heat sink against aluminum rudder it cools quite nicely and handles full load for long periods of time i used epoxy on the board to waterproof it and it works great pushing a 6 inch prop on brushless thruster at 24 volts with a kayak cruising speed of 4.3 mph
Wesley159
2025-08-06 11:42:14
I tried to build my own butCould not find schematics this fixed my issues on brushless motor which I've not had much experience
BRANDON CANTRELL
2025-08-02 18:02:05
The media could not be loaded.
Daisy
2025-07-09 16:59:17
Update Smoked after 2 min of use. Hard to belief this is supposed to hold 15 Amp and yes I added heat sink and fan.
Marlon j.
2025-04-07 15:42:17
Work with small motors
Mauricio
2025-02-20 18:41:16
Stop working after 2 hours of instalationWith 18v battery and only 3 ampsVery disappointed of this productThank you
Recommended Products
